EL-USB-2-LCD+ Lascar Electronics, EL-USB-2-LCD+ Datasheet - Page 3

• Manufacturer Part Number: EL-USB-2-LCD+
• Description: TEMP/RH USB DATA LOGGER, LCD, 2-1/2 DIGIT
• Manufacturer: Lascar Electronics

Specifications of EL-USB-2-LCD+

• Accuracy: ±2.0 %RH
• Humidity: 0-100 %RH
• Sample Rate: Every 10 Second to Every 12 Hours
• Temperature Accuracy: ±0.3 (±0.6) °C (°F)
• Temperature, Range, Measuring: –35 (–31) to 80 (176) °C (°F)
• Lead Free Status / Rohs Status: RoHS Compliant part

EL-USB-2-LCD+
EL-USB-2-LCD+
High Accuracy Humidity, Temperature and Dew Point Data Logger with LCD
High Accuracy Humidity, Temperature and Dew Point Data Logger with LCD
LCD INDICATION
LED FLASHING MODES
EL-USB-2-LCD+ features 2 bi-colour LEDs; one LED represents temperature measurement, the other represents RH. Each is clearly
marked on the logger. To save power, the status indication alternates between the two channels every 10 seconds. First you will
see the status of the temperature logging, and 10 seconds later you will see the status of the RH logging, and so on.
SpeciÀ cations liable to change without prior warning
RH% °C (°F)
Green LED
Red/
RH%
°C (°F)
Red/
Green LED
10 seconds later
* If the logger is set to “LCD off” or “LCD on for 30 seconds” mode, then this will only be shown after the button
is pressed. Otherwise the display will remain blank.
Display
Green double Á ash
The data logger is not currently logging, but is primed to start at a later date and time (delayed start).
Green single Á ash
The data logger is currently logging. No alarm on the channel.
Red single Á ash
The data logger is currently logging. Low alarm on the channel.
Red double Á ash
The data logger is currently logging. High alarm on the channel.
Green triple Á ash
The data logger is full and has stopped logging. No alarm on the channel.
Red triple Á ash
The data logger is full and has stopped logging. Alarm (high, low or both).
No LEDs Á ash
The data logger is stopped, the battery is empty or there is no battery À tted.
www.lascarelectronics.com
RH% °C (°F)
Issue 1
Logger Status
Delayed Start
Push to Start
Logging
Stopped
10/09
Explanation
This is shown when the logger is set to
start at a speciÀ c data and time*
This is shown when the logger is setup
for “Push to start” logging
This is shown when the logger is running
in “LCD off” mode, and the button is
pressed. The display clears again after
three seconds
If the logger has not been set to log and
the button is pressed, three dashes are
displayed for three seconds
S.C
Applies to EL-USB-2-LCD+
Page 3 of 5