DP-100NS-TRANSLUSCENT 3M, DP-100NS-TRANSLUSCENT Datasheet - Page 6

• Manufacturer Part Number: DP-100NS-TRANSLUSCENT
• Description: Adhesive; Epoxy; Translucent
• Manufacturer: 3M

Specifications of DP-100NS-TRANSLUSCENT

• Chemical Component: Amorphous Silica/Epoxy Resin
• Chemical System: Epoxy
• Color: Translucent
• Dispensing Method: Syringe
• Primary Type: Adhesive
• Time, Drying: Air Dry for 15 minutes, Force Dry for 10 minutes @ 66 °C +⁄- 5 °C (Aluminum Surface), If 3M™ Scotch-Weld™ Structural Primer 1945 B⁄A is Used, Apply a Thin Coating (0.5 mils) on the Metal Surfaces to be Bonded, Air Dry for 10 minutes, then Cure for 30 minu
• Time, Setting: 15 min. (Aluminum), 10 min. (Steel)
• Weight: 1.7 Oz.
• Lead Free Status / Rohs Status: RoHS Compliant part

5.2 EXTINGUISHING MEDIA
Ordinary combustible material. Use fire extinguishers with class A extinguishing agents (e.g., water, foam).
5.3 PROTECTION OF FIRE FIGHTERS
Special Fire Fighting Procedures:
(SCBA).
Unusual Fire and Explosion Hazards:
Accidental Release Measures: Observe precautions from other sections. Call 3M- HELPS line (1-800-364-3577) for more
information on handling and managing the spill. Contain spill. Collect as much of the spilled material as possible. Place in a closed
container approved for transportation by appropriate authorities.
7.1 HANDLING
Do not eat, drink or smoke when using this product. Wash exposed areas thoroughly with soap and water. Avoid breathing of vapors,
mists or spray. Avoid breathing of dust created by cutting, sanding, grinding or machining. Avoid contact with oxidizing agents. Do
not cure up a mass of combined material larger than 50 grams to prevent the possibility of exotherm.
7.2 STORAGE
Store away from acids. Store away from heat. Store out of direct sunlight. Store away from oxidizing agents.
8.1 ENGINEERING CONTROLS
Provide ventilated enclosure for heat curing. Provide appropriate local exhaust for cutting, grinding, sanding or machining. Curing
enclosures must be exhausted to outdoors or to a suitable emission control device.
8.2 PERSONAL PROTECTIVE EQUIPMENT (PPE)
8.2.1 Eye/Face Protection
Avoid eye contact.
The following eye protection(s) are recommended: Safety Glasses with side shields, Indirect Vented Goggles.
_________________________________________________________________________________________________
3M MATERIAL SAFETY DATA SHEET Scotch-Weld(TM) Epoxy Adhesive DP-100 NS, Translucent (Part B)
SECTION 6: ACCIDENTAL RELEASE MEASURES
SECTION 7: HANDLING AND STORAGE
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
In the event of a release of this material, the user should determine if the release qualifies as reportable according to
local, state, and federal regulations.
Note: See STABILITY AND REACTIVITY (SECTION 10) for hazardous combustion and thermal decomposition
information.
Autoignition temperature
Flash Point
Flammable Limits - LEL
Flammable Limits - UEL
Wear full protective equipment (Bunker Gear) and a self-contained breathing apparatus
Not applicable.
No Data Available
>=240 ºC [Test Method: Estimated]
Not Applicable
Not Applicable
Page 3 of 8