AT83C24-PRTIL Atmel, AT83C24-PRTIL Datasheet - Page 18

• Manufacturer Part Number: AT83C24-PRTIL
• Description: IC 8051 MCU W/SMART CARD 28QFN
• Manufacturer: Atmel

Specifications of AT83C24-PRTIL

• Controller Type: Smart Card Reader Interface
• Interface: 2-Wire
• Voltage - Supply: 3 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 28-QFN
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Current - Supply: -

Deactivation Sequence
18
AT83C24
The card automatic deactivation is triggered when one the following condition occurs:
•
•
•
•
•
•
•
It is a self-timed sequence which cannot be interrupted when started (see Figure 14). Each step
is separated by a delay based on Td equal to 8 periods of the DC/DC clock, typically 2 µs:
Notes:
Figure 14. Deactivation Sequence
ICARDERR bit is set by hardware
VCARDERR bit is set by hardware (or by software)
INSERT is set and CARDIN is cleared (card extraction)
SHUTDOWN is set by software
CMDVCC goes from Low to High
Power fail on VCC (see POWERMON bit in CONFIG4 register)
Reset pin going low
1. T0: CARDRST is cleared, SHUTDOWN bit set.
2. T0 + 5 x Td:CARDCK is cleared, CKSTOP, CARDIO and IODIS are set.
3. T0 + 6 x Td: CARDIO is cleared.
4. T0 + 7 x Td: VCARD[1-0] = 00.
1. Setting ICARDERR by software does not trigger a deactivation. VCARDERR can be used to
2. t1=5 to 5.5*Td, and t2=0.5*Td to Td.
deactivate the card by software.
CRST
CCLK
CVCC
CIO,
CC4,
CC8
t1
t2
Td
4234G–SCR–01/07