TDA8034HN/C1,118 NXP Semiconductors, TDA8034HN/C1,118 Datasheet - Page 10
![no-image](/images/manufacturer_photos/0/4/487/nxp_semiconductors_sml.jpg)
TDA8034HN/C1,118
Manufacturer Part Number
TDA8034HN/C1,118
Description
IC SMARD CARD INTERFACE 24HVQFN
Manufacturer
NXP Semiconductors
Datasheet
1.TDA8034HNC1118.pdf
(30 pages)
Specifications of TDA8034HN/C1,118
Controller Type
Smart Card Interface
Interface
Analog
Voltage - Supply
1.8V, 3V, 5V
Current - Supply
65mA
Operating Temperature
-25°C ~ 85°C
Mounting Type
Surface Mount
Package / Case
24-VQFN Exposed Pad, 24-HVQFN, 24-SQFN, 24-DHVQFN
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
NXP Semiconductors
TDA8034HN
Product data sheet
8.8 Deactivation sequence
When a session ends, the microcontroller sets pin CMDVCCN HIGH. The TDA8034HN
then executes an automatic deactivation sequence by counting the sequencer back to the
inactive state (see
Calculation of the time delays is as follows:
1. Pin RST is pulled LOW (t11).
2. The clock is stopped, pin CLK is LOW (t12).
3. Pins I/OUC, AUX1UC and AUX2UC are pulled LOW (t13).
4. V
5. V
6. All card contacts become low-impedance to GND. However, pins I/OUC, AUX1UC
7. The internal oscillator returns to its low frequency mode.
Fig 7.
•
•
•
•
•
CMDVCCN
XTAL1
V
I/O
CLK
RSTIN
RST
I/OUC
OSCINT
inactive state.
and AUX2UC remain pulled up to V
t11 = t10 + 3T / 64
t12 = t11 + T / 2
t13 = t11 + T
t14 = t11 + 3T / 2
t
CC
deac
CC
CC
falls to 0 V (t14). The deactivation sequence is completed when V
< 0.4 V (t
= t11 + 3T / 2 + V
OSCINT = internal oscillator.
Activation sequence at t3
low frequency
All information provided in this document is subject to legal disclaimers.
t0
deac
Figure
t1 = t2
Rev. 3.0. — 17 January 2011
)
8) as follows:
CC
t
d(start)
fall time
t4
> 200 ns
t
d(end)
DD
using the 11 kΩ resistor.
= t
act
high frequency
TDA8034HN
Smart card interface
© NXP B.V. 2011. All rights reserved.
CC
ATR
reaches its
001aal140
10 of 30