LAN9512-JZX SMSC, LAN9512-JZX Datasheet - Page 17

• Manufacturer Part Number: LAN9512-JZX
• Description: IC USB 2.0 ETHER CTRLR 64QFN
• Manufacturer: SMSC

Specifications of LAN9512-JZX

• Controller Type: Ethernet Controller
• Interface: IEEE 802.3
• Voltage - Supply: 3 V ~ 3.6 V
• Current - Supply: 231mA
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 64-QFN
• Product: Ethernet Controllers
• Standard Supported: 802.3, 802.3u
• Data Rate: 1.5 Mbps to 480 Mbps
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 3 V
• Supply Current (max): 231 mA
• Maximum Operating Temperature: + 70 C
• Ethernet Connection Type: 10/100 Base-T
• Maximum Power Dissipation: 763 mW
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• For Use With: 638-1093 - EVALUATION BOARD FOR LAN9512
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 638-1086

USB 2.0 Hub and 10/100 Ethernet Controller
Datasheet
SMSC LAN9512/LAN9512i
2.1.2
Port Power Control Using a Poly Fuse
When using the LAN9512/LAN9512i with a poly fuse, an external diode must be used (See
When disabling port power, the driver will drive a ‘0’. This procedure will have no effect since the
external diode will isolate the pin from the load. When port power is enabled, the output driver is
disabled and the pull-up resistor is enabled, which creates an open drain output. This means that the
pull-up resistor is providing 3.3 volts to the anode of the diode. If there is an over-current situation, the
poly fuse will open. This will cause the cathode of the diode to go to 0 volts. The anode of the diode
will be at 0.7 volts, and the Schmidt trigger input will register this as a low, resulting in an overcurrent
detection. The open drain output does not interfere.
LAN9512/
LAN9512i
Figure 2.3 Port Power Control with Poly Fuse
DATASHEET
PRTCTL3
PRTCTL2
17
Device
Device
USB
USB
5V
5V
Poly Fuse
Poly Fuse
Revision 1.0 (11-24-09)
Figure
2.3).