MC68306FC16B Freescale Semiconductor, MC68306FC16B Datasheet - Page 112

• Manufacturer Part Number: MC68306FC16B
• Description: IC MPU INTEGRATED 132-PQFP
• Manufacturer: Freescale Semiconductor

Specifications of MC68306FC16B

• Processor Type: M683xx 32-Bit
• Speed: 16MHz
• Voltage: 5V
• Mounting Type: Surface Mount
• Package / Case: 132-MQFP, 132-PQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Features: -

The TIRQ interrupt (if enabled) is fixed at level seven. When a level seven interrupt is
acknowledged, the TIRQ interrupt is serviced before the external IRQ7. If the serial
module IRQ is also programmed at level seven, the TIRQ interrupt is serviced first, then
the serial module IRQ, then the external IRQ7 last.
If the TIRQ interrupt is enabled, the serial module counter/timer ready interrupt in the
DUISR should be masked, and the IRQ service routine should not service the
counter/timer ready condition.
6.1.5 Comparison of Serial Module to MC68681
The serial module is code compatible with the MC68681 with some modifications, but
OP2, OP4–7, and IP3–5 are not pinned out. A new interrrupt output (TIRQ) is available.
6.2 SERIAL MODULE SIGNAL DEFINITIONS
The following paragraphs contain a brief description of the serial module signals. Figure 6-
2 shows both the external and internal signal groups.
6.2.1 Crystal Input or External Clock (X1/CLK)
This input is one of two connections to a crystal or a single connection to an external
clock. A crystal or an external clock signal, at 3.6864 MHz, must be supplied when using
the baud rate generator. If a crystal is used, a capacitor of approximately 10 pF should be
connected from this signal to ground. If this input is not used, it must be connected to V
or GND.
6.2.2 Crystal Output (X2)
This output is the additional connection to a crystal. If a crystal is used, a capacitor of
approximately 5 pF should be connected from this signal to ground. If an external CMOS-
level clock is used on X1/CLK, the X2 output must be left open.
6.2.3 Channel A Transmitter Serial Data Output (TxDA)
This signal is the transmitter serial data output for channel A. The output is held high
('mark' condition) when the transmitter is disabled, idle, or operating in the local loopback
mode. Data is shifted out on this signal on the falling edge of the clock source, with the
least significant bit transmitted first.
6-4
The terms assertion and negation are used throughout this
section to avoid confusion when dealing with a mixture of
active-low and active-high signals. The term assert or assertion
indicates that a signal is active or true, independent of the level
represented by a high or low voltage. The term negate or
negation indicates that a signal is inactive or false.
Freescale Semiconductor, Inc.
For More Information On This Product,
MC68306 USER'S MANUAL
Go to: www.freescale.com
NOTE
MOTOROLA
CC