20-101-0654 Rabbit Semiconductor, 20-101-0654 Datasheet - Page 8

• Manufacturer Part Number: 20-101-0654
• Description: INTERFACE OP6800 512K FLASH&SRAM
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0654

• Module/board Type: Single Board Computer Module
• Product: Modules
• Processor Type: Rabbit 2000
• Sram: 128 KB
• Flash: 256 KB
• Timers: 8 bit, 10 bit
• Backup Battery: Lithium Battery
• Operating Voltage: 9 V to 36 V
• Power Consumption: 1.5 W
• Board Size: 111 mm x 91 mm x 33 mm
• Description/function: Computer Module
• For Use With/related Products: OP6800
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 20-101-654; 20-101-654

1.4 CE Compliance
Equipment is generally divided into two classes.
These limits apply over the range of 30–230 MHz. The limits are 7 dB higher for frequencies
above 230 MHz. Although the test range goes to 1 GHz, the emissions from Rabbit-based
systems at frequencies above 300 MHz are generally well below background noise levels.
The OP6800 has been tested and was found to be in conformity with
the following applicable immunity and emission standards. The OP6810
is also CE qualified as it is a sub-version of the OP6800. Boards that
are CE-compliant have the CE mark.
Immunity
The OP6800 operator interfaces meet the following EN55024/1998 immunity standards.
• EN61000-4-2 (ESD)
• EN61000-4-3 (Radiated Immunity)
• EN61000-4-4 (EFT)
• EN61000-4-6 (Conducted Immunity)
Additional shielding or filtering may be required for a heavy industrial environment.
Emissions
The OP6800 operator interfaces meet the following emission standards emission stan-
dards with the Rabbit 2000 spectrum spreader turned on and set to the normal mode. The
spectrum spreader is only available with Rev. C or higher of the Rabbit 2000 microproces-
sor. This microprocessor is used on the OP6800 operator control panels that carry the CE
mark.
• EN55022:1998 Class B
• FCC Part 15 Class B
Your results may vary, depending on your application, so additional shielding or filtering
may be needed to maintain the Class B emission qualification.
4
Digital equipment meant for light industrial use
Less restrictive emissions requirement:
less than 40 dB µV/m at 10 m
(40 dB relative to 1 µV/m) or 300 µV/m
NOTE: Earlier versions of the OP6800 sold before 2003 that do not
have the CE mark are not CE-complaint.
CLASS A
Digital equipment meant for home use
More restrictive emissions requirement:
30 dB µV/m at 10 m or 100 µV/m
CLASS B
MiniCom (OP6800)