20-101-0497 Rabbit Semiconductor, 20-101-0497 Datasheet - Page 26

• Manufacturer Part Number: 20-101-0497
• Description: MODULE OP6810 W/O ETH/MEM EXPANS
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0497

• Module/board Type: Single Board Computer Module
• Product: Prototyping Accessories
• Processor Type: Rabbit 2000
• Sram: 128 KB
• Flash: 256 KB
• Timers: 8 bit, 10 bit
• Number Of I/os: 24
• Operating Voltage: 9 V to 36 V
• Power Consumption: 1.5 W
• Board Size: 111 mm x 91 mm x 33 mm
• For Use With/related Products: OP6810
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 20-101-497; 20-101-497

3.3.4 Ethernet Port (OP6800 models only)
Figure 13 shows the pinout for the Ethernet port (J2 on the OP6800 module). Note that
there are two standards for numbering the pins on this connector—the convention used
here, and numbering in reverse to that shown. Regardless of the numbering convention
followed, the pin positions relative to the spring tab position (located at the bottom of the
RJ-45 jack in Figure 13) are always absolute, and the RJ-45 connector will work properly
with off-the-shelf Ethernet cables.
Figure 13. RJ-45 Ethernet Port Pinout
RJ-45 pinouts are sometimes numbered opposite to the way shown in Figure 13.
Two LEDs are placed next to the RJ-45 Ethernet jack, one to indicate an Ethernet link
(
LNK
) and one to indicate Ethernet activity (
ACT
).
The transformer/connector assembly ground is connected to the BL2100 module printed
circuit board digital ground via a 0 Ω resistor “jumper,” R29, as shown in Figure 14.
Figure 14. Isolation Resistor R29
The factory default is for the 0 Ω resistor “jumper” at R29 to be installed. In high-noise
environments, remove R29 and ground the transformer/connector assembly directly
through the chassis ground. This will be especially helpful to minimize ESD and/or EMI
problems.
22
MiniCom (OP6800)