101-0600 Rabbit Semiconductor, 101-0600 Datasheet - Page 37

• Manufacturer Part Number: 101-0600
• Description: COMPUTER SNGLBD BL2510 512K FLSH
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0600

• Module/board Type: Single Board Computer Module
• For Use With/related Products: BL2510
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

3.5.3 Programming Port
The Coyote’s serial programming port is accessed via the 10-pin programming header on
the RabbitCore module or over an Ethernet connection via the RabbitLink EG2110. The
programming port uses the Rabbit 3000’s Serial Port A for communication. Dynamic C
uses the programming port to download and debug programs.
The programming port is also used for the following operations.
• Cold-boot the Rabbit 3000 on the RabbitCore module after a reset.
• Remotely download and debug a program over an Ethernet connection using the
• Fast copy designated portions of flash memory from one Rabbit-based board (the
Alternate Uses of the Programming Port
All three clocked Serial Port A signals are available as
• a synchronous serial port
• an asynchronous serial port, with the clock line usable as a general CMOS I/O pin
The programming port may also be used as a serial port via the
programming cable.
In addition to Serial Port A, the Rabbit 3000 startup-mode (SMODE0, SMODE1), status,
and reset pins are available on the programming port.
The two startup mode pins determine what happens after a reset—the Rabbit 3000 is
either cold-booted or the program begins executing at address 0x0000.
The status pin is used by Dynamic C to determine whether a Rabbit microprocessor is
present. The status output has three different programmable functions:
1. It can be driven low on the first op code fetch cycle.
2. It can be driven low during an interrupt acknowledge cycle.
3. It can also serve as a general-purpose output.
The /RESET_IN pin is an external input that is used to reset the Rabbit 3000 and the
RCM3400 onboard peripheral circuits. The serial programming port can be used to force a
hard reset on the RCM3400 by asserting the /RESET_IN signal.
Refer to the
3.5.4 RabbitNet Ports
The RJ-45 jacks labeled RabbitNet are multiplexed clocked SPI RS-422 serial I/O expan-
sion ports for use with peripheral cards currently being developed. The RabbitNet jack
does not support Ethernet connections.
User’s Manual
RabbitLink EG2110.
master) to another (the slave) using the Rabbit Cloning Board.
Rabbit 3000 Microprocessor User’s Manual
for more information.
DIAG
connector on the
31