DC-ME-Y402-LX Digi International, DC-ME-Y402-LX Datasheet - Page 24

• Manufacturer Part Number: DC-ME-Y402-LX
• Description: ME 9210 8MB RAM 4MB FLASH LINUX
• Manufacturer: Digi International
• Type: Network Controller & Processorr

Specifications of DC-ME-Y402-LX

• Module/board Type: Device Server
• Data Rate: 10 Mbps to 100 Mbps
• Memory Type: SDRAM
• Interface Type: Ethernet
• Operating Voltage: 3.3 V
• Operating Current: 346 mA
• Maximum Power Dissipation: 825 mW
• Operating Temperature Range: - 40 C to + 80 C
• Board Size: 36.7 mm x 19.05 mm
• Data Bus Width: 32 bit
• Modulation: CCK, DBPSK, DQPSK
• Product: Modules
• Security: 64/128 bit WEP, TKIP, WPA, WPA2
• For Use With/related Products: Networking
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Module JTAG Interface Connector, P11
JTAG Debugger Connector, P12
Note:
Note:
The Module JTAG Interface Connector is a 14-pin female vertical header that is labeled
P11 on the development board. The connector mates with the JTAG connector on the Digi
Connect ME embedded module. The Module JTAG Connector pins are tied to the JTAG
debugger Connector (see “JTAG Debugger Connector, P12”).
Note:
The JTAG debugger connector is a 20-pin male vertical header that is labeled P12 on the
development board. The connector mates with a JTAG debugger plug (for example, a Digi
JTAG Link). The connector is used with the development kit only. See the following figure
for pin orientation. See the following table for pin assignments.
Note:
Pin
19
20
The Digi Connect Wi-ME module does not provide pins 1-6
See "Module Pinout" on page 33 for detailed IO configuration information.
Because there is no direct connection to the Module JTAG Interface
Connector, pin orientation and pin assignments are not described for the
connector.
The figure shows the connector using the same orientation as shown in the
figure titled "Board Layout and Connector Locations:" on page 17.
/INIT
ME
Module Connector Pin Assignments
Signal
/INIT
Wi-ME
Reserved
Digi Plug-and-Play Firmware Software
Reset
Description
      
2 4