EP1C3T144C8 Altera, EP1C3T144C8 Datasheet - Page 68

• Manufacturer Part Number: EP1C3T144C8
• Description: IC CYCLONE FPGA 2910 LE 144-TQFP
• Manufacturer: Altera
• Series: Cyclone®r

Specifications of EP1C3T144C8

• Number Of Logic Elements/cells: 2910
• Number Of Labs/clbs: 291
• Total Ram Bits: 59904
• Number Of I /o: 104
• Voltage - Supply: 1.425 V ~ 1.575 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 144-TQFP, 144-VQFP
• Family Name: Cyclone®
• Number Of Logic Blocks/elements: 2910
• # I/os (max): 104
• Frequency (max): 275.03MHz
• Process Technology: 0.13um (CMOS)
• Operating Supply Voltage (typ): 1.5V
• Logic Cells: 2910
• Ram Bits: 59904
• Operating Supply Voltage (min): 1.425V
• Operating Supply Voltage (max): 1.575V
• Operating Temp Range: 0C to 85C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 144
• Package Type: TQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Number Of Gates: -
• Lead Free Status / Rohs Status: Not Compliant
• Other names: 544-1052

Cyclone Device Handbook, Volume 1
3–6
Preliminary
Operating Modes
The Cyclone architecture uses SRAM configuration elements that require
configuration data to be loaded each time the circuit powers up. The
process of physically loading the SRAM data into the device is called
configuration. During initialization, which occurs immediately after
configuration, the device resets registers, enables I/O pins, and begins to
operate as a logic device. Together, the configuration and initialization
processes are called command mode. Normal device operation is called
user mode.
SRAM configuration elements allow Cyclone devices to be reconfigured
in-circuit by loading new configuration data into the device. With real-
time reconfiguration, the device is forced into command mode with a
device pin. The configuration process loads different configuration data,
reinitializes the device, and resumes user-mode operation. Designers can
perform in-field upgrades by distributing new configuration files either
within the system or remotely.
A built-in weak pull-up resistor pulls all user I/O pins to V
and during device configuration.
The configuration pins support 1.5-V/1.8-V or 2.5-V/3.3-V I/O
standards. The voltage level of the configuration output pins is
determined by the V
V
3.3-V compatible.
Configuration Schemes
Designers can load the configuration data for a Cyclone device with one
of three configuration schemes (see
target application. Designers can use a configuration device, intelligent
controller, or the JTAG port to configure a Cyclone device. A low-cost
configuration device can automatically configure a Cyclone device at
system power-up.
CCIO
selects whether the configuration inputs are 1.5-V, 1.8-V, 2.5-V, or
CCIO
of the bank where the pins reside. The bank
Table
3–5), chosen on the basis of the
Altera Corporation
CCIO
May 2008
before