ST626XCKITEU STMicroelectronics, ST626XCKITEU Datasheet - Page 29

• Manufacturer Part Number: ST626XCKITEU
• Manufacturer: STMicroelectronics

Specifications of ST626XCKITEU

• Lead Free Status / Rohs Status: Supplier Unconfirmed

To run WGDB6:
• If you are using Windows 95, click the Start button, point to Programs, then ST6 Tools,
• If you are using Windows 3.x, double-click the appropriate WGDB6/Simulator icon in the
Refer to "WGDB6 User Guide" in the "ST6 Family Software Development Tools AST6, LST6,
WGDB6" User Manual for full instructions on how to use WGDB6.
6.3 Error Messages
The following table lists the error messages you may encounter when using WGDB6 with the
Starter Kit board:
6.4 Troubleshooting
If there is a communications problem between WGDB6 and the Starter kit board, the title
“WGDB6 Simulator” appears in the WGDB6 title bar. In this case, you shoud check the follow-
ing:
• That the Starter Kit board is correctly powered up.
• That the parallel port cable is correctly connected.
• That the device jumpers W1and W2 are in the USER position.
• That the device type selection jumpers W10 to W13 are in the ST6265 position.
• That an ST6265 is plugged into the Starter Kit board, and it is programmed with
Error message
Error 116 Port A protected when using
board.
Error 117 Communication error with
ST626x board.
then click WGDB6/Simulator.
ST6 Tools program group.
DEMOK65.HEX.
Using The Starter Kit Board as a Hardware Simulator
Description
This means that WGDB6 tried to access the PORT A
registers. These are used for communications with the
board.
This means that a problem occurred during communcations
between the host PC and the board. Perform the checks
listed below.
29/41
33