E2CY-V3A Omron, E2CY-V3A Datasheet - Page 7

• Manufacturer Part Number: E2CY-V3A
• Description: Proximity Sensors NON-FERROUS PROX HEA D FLAT
• Manufacturer: Omron
• Series: E2CYr

Specifications of E2CY-V3A

• Output Type: NPN
• Proximity Sensor Sensing Distance: 3mm
• Proximity Sensor Sensing Distance Range: 2 to 7mm
• Mounting: Panel
• Operating Temp Range: -10C to 55C
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 10V
• Operating Supply Voltage (typ): 12/15/18/24V
• Operating Supply Voltage (max): 30V
• Pin Count: 3
• Maximum Operating Temperature: + 55 C
• Operating Supply Voltage: 10 V to 30 V
• Sensing Distance: 3 mm
• Minimum Operating Temperature: - 10 C
• Sensor Type: Inductive
• Sensing Object: Metallic
• Response Frequency: -
• Material - Body: Zinc Die-Cast
• Shielding: Shielded
• Voltage - Supply: -
• Terminal Type: 3-Wire
• Package / Case: Box
• Lead Free Status / Rohs Status: Supplier Unconfirmed

Positioning Teaching
AUTO Mode
This mode is used for adjusting the target distance to its maximum without using any target object.
Note: If the operation mode selector is set to AUTO when the E2CY is turned ON, the E2CY will make sensitivity adjustments automati-
E2CY
Step 1
Step 2
Step 3
Step 4
Set the operation mode selector
to AUTO with no target object
located at the sensing distance
located at the sensing distance.
cally. To maintain the sensitivity after adjustment, be sure to set the operation mode selector to RUN.
Set the operation
mode selector to T.
Press the TEACH
button once with no
target object
located.
Press the TEACH
button once after
locating the target
object at the
desired teaching
position.
If all the indicators
flash, repeat from
step 1.
Press the TEACH
button once with
the target object
located at the same
position.
If all the indicators
flash, repeat from
step 1.
Set the operation
mode selector to
RUN.
g
j
The sensing distance is automatically
set to 80% to 110% of the stable
sensing distance of the E2CY.
Status of target object
Status of target object
Status of target object
Sensitivity setting
position
Status of target object
ON point
Target object at a
certain position
Target object at a
certain position
No target object
No target object
The ON-point is set at
the teaching position.
Sensor Head
Sensor Head
Sensor Head
Sensor Head
Sensor Head
Control panel
Control panel
Control panel
Control panel
Control panel
Operation mode selector
TEACH button
TEACH button
TEACH button
TEACH button
Sensor
Head side
OFF after the
indicators are
ON for 1 s.
Indicators
(Excess gain level indicators)
Indicators
(Excess gain level indicators)
Indicators
(Excess gain level indicators)
Indicators
(Excess gain level indicators)
Indicators
(Excess gain level indicators)
Sensor
Head side
Sensor
Head side
ON
ON
Sensor
Head side
OFF after the
indicators are
ON for 1 s.
Sensor
Head side
ON
OK
OK
OK
OK
OK
Sensor
Head side
Sensor
Head side
Sensor
Head side
Flashing
Flashing
Flashing
No good
No good
No good
E2CY
7