E2CY-V3A Omron, E2CY-V3A Datasheet - Page 4

• Manufacturer Part Number: E2CY-V3A
• Description: Proximity Sensors NON-FERROUS PROX HEA D FLAT
• Manufacturer: Omron
• Series: E2CYr

Specifications of E2CY-V3A

• Output Type: NPN
• Proximity Sensor Sensing Distance: 3mm
• Proximity Sensor Sensing Distance Range: 2 to 7mm
• Mounting: Panel
• Operating Temp Range: -10C to 55C
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 10V
• Operating Supply Voltage (typ): 12/15/18/24V
• Operating Supply Voltage (max): 30V
• Pin Count: 3
• Maximum Operating Temperature: + 55 C
• Operating Supply Voltage: 10 V to 30 V
• Sensing Distance: 3 mm
• Minimum Operating Temperature: - 10 C
• Sensor Type: Inductive
• Sensing Object: Metallic
• Response Frequency: -
• Material - Body: Zinc Die-Cast
• Shielding: Shielded
• Voltage - Supply: -
• Terminal Type: 3-Wire
• Package / Case: Box
• Lead Free Status / Rohs Status: Supplier Unconfirmed

E2CY
T Mode
Teaching Without Target Object
Note: After the E2CY is set to RUN mode, approximately 1.5 s will be required until the sensitivity is set from the moment the first target
4
Step 1
Step 2
Step 3
In
Operation
p
object passes the sensing position. Therefore, move the next target object so that it passes through the sensing position 1.5 s after
the first target object passes the sensing position. Once the sensitivity adjustment is made, it will operate under the normal
response frequency.
Set the operation
mode selector to T.
Press the TEACH
button once with no
target object
located.
If all the indicators
flash, press the
TEACH button
again.
Set the operation
mode selector to
RUN.
Move the target
object so that it
passes through the
sensing position
once.
---
Status of target object
Status of target object
Status of target object
Sensitivity setting
position
The ON point is set to a
distance that is approxi-
mately 1.2 times larger
than the distance between
the position where the
sample sensing object
passes and the sensing
surface of the Sensor
Head.
ON
point
No target object
No target object
Target
object
Sensor Head
Sensor Head
Target
object
passing
Sensor Head
Sensor Head
Control panel
Control panel
Control panel
No switches are operated.
---
Operation mode selector
TEACH button
Indicators
(Excess gain level indicators)
Indicators
(Excess gain level indicators)
Indicators
(Excess gain level indicators)
---
Sensor
Head side
ON
Sensor
Head side
Sensor
Head side
OFF after the
indicators are
ON for 1 s.
OK
OFF
OK
Sensor
Head side
Flashing
No good
E2CY