35TLV470M12.5X13.5 RUBYCON, 35TLV470M12.5X13.5 Datasheet - Page 6

• Manufacturer Part Number: 35TLV470M12.5X13.5
• Description: CAPACITOR, SMD, 35V, 470UF
• Manufacturer: RUBYCON
• Series: TLVr

Specifications of 35TLV470M12.5X13.5

• Capacitor Dielectric Type: Aluminium Electrolytic
• Capacitance: 470µF
• Capacitance Tolerance: ± 20%
• Voltage Rating: 35V
• Life Time @ Temperature: 5000 Hours @ 105°C
• Height: 13.5mm
• Diameter: 12.5mm
• Rohs Compliant: Yes
• Capacitor Mounting: SMD
• Lead Spacing: 4.5mm

10. Notes on use of aluminum electrolytic capacitors
♦
Guide to application except the above are described in our catalog and EIAJ RCR-2367C.
(7) PC board cleaning after soldering
<Storage Condition>
(6) Fumigation and halogenated flame retardant
9-7. Adhesion test.
9-8. Carrier tape shall be reeled whose embossed part is inside. (Top-cover tape shall be outside.)
(1) Charge and discharge
(2) External stress
(3) Heat resistance at soldering process
(4) Adhesives and coating materials
(5) Storage
EIAJ RCR-2367C: “Safety Application Guide for fixed aluminum electrolytic capacitors for use in electronic equipment."
Do not use for the circuit that repeats quick charge or discharge
soldering temperature is too high and /or soldering time is too long.
at pre-heating, heating at hardening process of adhesive and soldering process.
any trouble that high leakage current possibly causes, voltage treatment is recommended for the capacitors that have been stored for
a long time.
storage condition is 5°C-35°C and less than 75% in relative humidity.
acid, chlorine gas, ammonia or bromine gas).
*Fumigation of wooden pallets before shipment to disinfect vermin.
*Existence of components or parts that contain halogenated flame retardant agent (bromine etc.) together with capacitors.
*When halogenated detergents or antiseptics for preventing infection of epidemic diseases contact directly to capacitors.
Do not apply excessive force of pushing, pulling bending, and/or twisting to the main body, lead wire and terminals.
In the soldering process of PC board with Capacitors mounted, secondary shrinkage or crack of sleeve may be observed when
If lead wire of other components or pattern of double sided PC board touches the capacitor, the similar failure may be also originated
Do not use the adhesives and coating materials that contain halogenated organic solvents or chloroprene as polymer.
Keep at a normal temperature and humidity. During a long storage time, leakage current will be increased. To prevent heat rise or
Please consult us when cleaning is subjected.
*Aluminum electrolytic capacitors should not be stored in high temperatures or where there is a high level of humidity. The suitable
*Aluminum electrolytic capacitors should not be stored in damp conditions such as water, saltwater spray or oil spray.
*Do not store aluminum electrolytic capacitors in an environment full of hazardous gas (hydrogen sulfide, sulfurous acid gas, nitrous
*Aluminum electrolytic capacitors should not be stored under exposure to ozone, ultraviolet rays or radiation.
It may cause corrosion of internal electrodes, aluminum cases and terminal surface when the following conditions exist.
TLV SERIES
carrier tape
leading direction
Published by Japan Electronics and Information Technology Industries Association.
165 to 180
RUBYCON CORPORATION
 
pulling strength 0.10 to 1.30N
pulling speed 5mm/sec.
top -cover tape
pulling direction
PAGE
5 / 5