66253-2 TE Connectivity, 66253-2 Datasheet - Page 3

• Manufacturer Part Number: 66253-2
• Description: MALE CONTACT ASSY. (STRIP)
• Manufacturer: TE Connectivity
• Series: Type XIIr

Specifications of 66253-2

• Rohs Compliant: YES
• Insulation Support: Yes
• Termination Method To Wire/cable: Crimp
• Wire/cable Type: Discrete Wire
• Grade: Commercial
• High Current: No
• Termination End Plating: Gold (30)
• Wire Range (mm [awg]): 5.00-8.00² [10 - 8]
• Used With: G Series Connectors, CPC Connectors, M Series Connectors
• Contact Type: Pin
• Contact Classification: Power
• Contact Plating, Mating Area, Material: Gold (30)
• Contact Base Material: Copper
• Contact Size: Power Contact
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Accepts Wire Insulation Diameter, Range (mm [in]): 4.83 – 5.59 [0.190 – 0.220]
• Applies To: Wire/Cable
• Test Current (a): 35.0
• Packaging Method: Strip

3.6.
4.
4.1.
4.2.
4.3.
4.4.
Rev B
Product Qualification and Requalification Test Sequence
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form , fit or function are m ade to the product or m anufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determ ined by developm ent/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product m eets the requirem ents of Figure 1. Failures
attributed to equipm ent, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and specim ens resubm itted for qualification. Testing to
confirm corrective action is required before resubm ittal.
Quality Conform ance Inspection
The applicable AMP quality inspection plan shall specify the sam pling acceptable quality level to be
used. Dim ensional and functional requirem ents shall be in accordance with the applicable product
drawing and this specification.
NOTE
Specim en Selection
Specim ens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. All test groups shall each consist of 3 specim ens.
Test Sequence
Qualification inspection shall be verified by testing specim ens as specified in Figure 2.
(a)
(b)
See paragraph 4.1.A.
Numbers indicate sequence in which tests are performed.
Initial exam ination of product
Tem perature rise vs current
Contact retention
Final exam ination of product
Test or Exam ination
Figure 2
Test Sequence (b)
Test Group (a)
1
1
2
3
1
3
2
2
108-10024-4
3 of 4