66253-2 TE Connectivity, 66253-2 Datasheet - Page 2

• Manufacturer Part Number: 66253-2
• Description: MALE CONTACT ASSY. (STRIP)
• Manufacturer: TE Connectivity
• Series: Type XIIr

Specifications of 66253-2

• Rohs Compliant: YES
• Insulation Support: Yes
• Termination Method To Wire/cable: Crimp
• Wire/cable Type: Discrete Wire
• Grade: Commercial
• High Current: No
• Termination End Plating: Gold (30)
• Wire Range (mm [awg]): 5.00-8.00² [10 - 8]
• Used With: G Series Connectors, CPC Connectors, M Series Connectors
• Contact Type: Pin
• Contact Classification: Power
• Contact Plating, Mating Area, Material: Gold (30)
• Contact Base Material: Copper
• Contact Size: Power Contact
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Accepts Wire Insulation Diameter, Range (mm [in]): 4.83 – 5.59 [0.190 – 0.220]
• Applies To: Wire/Cable
• Test Current (a): 35.0
• Packaging Method: Strip

3.
3.1.
3.2.
3.3.
3.4.
3.5.
Rev B
Initial exam ination of product.
Final exam ination of product.
Tem perature rise vs current.
Contact retention.
NOTE
REQUIREM ENTS
Design and Construction
Product shall be of the design, construction and physical dim ensions specified on the applicable product
drawing.
Materials
Materials used in the construction of this product shall be as specified on the applicable product
drawing.
Ratings
!
!
!
!
Perform ance and Test Description
Product is designed to m eet the electrical, m echanical and environm ental perform ance requirem ents
specified in Figure 1. Unless otherwise specified, all tests shall be perform ed at am bient environm ental
conditions per Test Specification 109-1.
Test Requirem ents and Procedures Sum m ary
Test Description
Voltage: 600 volts AC/DC
Current: 47.48 am peres (single circuit energized on 10 AW G wire)
Tem perature: -55 to 105°C
VDE 0627: XA/630/4KV/2 - Series I, VDE tested only
Shall meet visual requirements, show no physical damage, and meet requirements of additional
tests as specified in the Product Qualification and Requalification Test Sequence shown in Figure
2.
Meets requirem ents of product
drawing.
Meets visual requirem ents.
30 C m axim um tem perature rise at
specified current.
80.09 N [18 lb].
See Note.
MECHANICAL
ELECTRICAL
Requirem ent
Figure 1
EIA-364.
EIA-364.
Visual and dim ensional inspection
per product drawing.
Visual inspection.
EIA-364-70.
Measure tem perature rise vs
current.
See Figure 3.
IEC 60512-15-1.
Procedure
108-10024-4
2 of 4