AD7731BR-REEL7 Analog Devices Inc, AD7731BR-REEL7 Datasheet - Page 38

• Manufacturer Part Number: AD7731BR-REEL7
• Description: IC ADC 24BIT SIGMA-DELTA 24-SOIC
• Manufacturer: Analog Devices Inc

Specifications of AD7731BR-REEL7

• Rohs Status: RoHS non-compliant
• Number Of Bits: 24
• Sampling Rate (per Second): 6.4k
• Data Interface: DSP, Serial, SPI™
• Number Of Converters: 1
• Power Dissipation (max): 125mW
• Voltage Supply Source: Analog and Digital
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 24-SOIC (0.300", 7.50mm Width)
• For Use With: EVAL-AD7731EBZ - BOARD EVALUATION FOR AD7731

AD7731
The 8XC51 is configured in its Mode 0 serial interface mode.
Its serial interface contains a single data line. As a result, the
DATA OUT and DATA IN pins of the AD7731 should be
connected together. This means that the AD7731 must not be
configured for continuous read operation when interfacing to
the 8XC51. The serial clock on the 8XC51 idles high between
data transfers and, therefore, the POL input of the AD7731
should be hard-wired to a logic high. The 8XC51 outputs the
LSB first in a write operation while the AD7731 expects the
MSB first so the data to be transmitted has to be rearranged
before being written to the output serial register. Similarly, the
AD7731 outputs the MSB first during a read operation while
the 8XC51 expects the LSB first. Therefore, the data read into
the serial buffer needs to be rearranged before the correct data
word from the AD7731 is available in the accumulator.
8XC51
Figure 19. AD7731 to 8XC51 Interface
P3.0
P3.1
DV
DD
SYNC
RESET
POL
DATA OUT
DATA IN
SCLK
CS
AD7731
–38–
AD7731 to ADSP-2103/ADSP-2105 Interface
Figure 20 shows an interface between the AD7731 and the
ADSP-2105 DSP processor. In the interface shown, the RDY
bit of the Status Register is again monitored to determine when
the Data Register is updated. The alternative scheme is to use
an interrupt driven system, in which case the RDY output is
connected to the IRQ2 input of the ADSP-2105. The RFS and
TFS pins of the ADSP-2105 are configured as active low out-
puts and the ADSP-2105 serial clock line, SCLK, is also config-
ured as an output. The POL pin of the AD7731 is hard-wired
low. Because the SCLK from the ADSP-2105 is a continuous
clock, the CS of the AD7731 must be used to gate off the clock
once the transfer is complete. The CS for the AD7731 is active
when either the RFS or TFS outputs from the ADSP-2105 are
active. The serial clock rate on the ADSP-2105 should be lim-
ited to 3 MHz to ensure correct operation with the AD7731.
Figure 20. AD7731 to ADSP-2105 Interface
ADSP-2105
SCLK
RFS
TFS
DR
DT
DV
DD
SYNC
RESET
CS
DATA OUT
DATA IN
SCLK
POL
AD7731
REV. A
REV. 0