E2K-X4ME2 5M Omron, E2K-X4ME2 5M Datasheet - Page 11

• Manufacturer Part Number: E2K-X4ME2 5M
• Description: Proximity Sensors E2K-X4ME2 W/ 5 METER CABLE
• Manufacturer: Omron
• Series: E2K-Xr
• Type: Proximity Sensorr

Specifications of E2K-X4ME2 5M

• Proximity Sensor Sensing Distance: 4mm
• Proximity Sensor Sensing Distance Range: 2 to 7mm
• Proximity Sensor Switching Mode: NC
• Mounting: Panel
• Operating Temp Range: -25C to 70C
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 10V
• Operating Supply Voltage (typ): 12/15/18/24V
• Operating Supply Voltage (max): 30V
• Pin Count: 3
• Output Type: NPN
• Maximum Operating Temperature: + 70 C
• Supply Voltage: 12 VDC to 24 VDC
• Supply Current: 15 mA
• Output Voltage: 1 V
• Operating Supply Voltage: 10 VDC to 30 VDC
• Mounting Style: Panel
• Sensing Distance: 4 mm
• Minimum Operating Temperature: - 25 C
• Current Rating: 200 mA
• Features: Permits non-contact detection of metallic and non-metallic objects
• Voltage Rating: 24 VDC
• Lead Free Status / RoHS Status: Supplier Unconfirmed

Loads with Large Inrush Current
Loads, such as lamps or motors, that cause a large inrush
weaken or damage the switching element. In this situation, use a
relay.
* E2K, TL-N@Y: 1 A or higher
●Mounting
Mounting the Sensor
When mounting a Sensor, do not tap it with a hammer or otherwise
subject it to excessive shock. This will weaken water resistance and
may damage the Sensor. If the Sensor is being secured with bolts,
observe the allowable tightening torque. Some models require the
use of toothed washers.
For details, refer to the mounting precautions in Precautions for
Correct Use in individual product information.
Mounting/Removing Using DIN Track
(Example for E2CY)
<Mounting>
(1)Insert the front of the Sensor into the special Mounting Bracket
(2)Press the rear of the Sensor into the special Mounting Bracket or
• When mounting the side of the Sensor using the special Mounting
Bracket, first secure the Amplifier Unit to the special Mounting
Bracket, and then mount the special Mounting Bracket with M3
screws and flat washers with a diameter of 6 mm maximum.
(included) or DIN Track.
DIN Track.
Front
http://www.ia.omron.com/
Flat washers (6 dia. max.)
DIN Track (or Mounting Bracket)
(1)
Rear
(2)
Mounting track (yellow)
current*
will
Proximity Sensors Technical Guide
<Removing>
Set Distance
The sensing distance may vary due to fluctuations in temperature and
voltage. When mounting the Sensor, it is recommend that installation
be based on the set distance.
• While pressing the Amplifier Unit in the direction of (3), lift the fiber
plug in the direction of (4) for easy removal without a screwdriver.
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
(4)
DIN Track
(3)
C-5