PPC405GPR-3KB266 Applied Micro Circuits Corporation, PPC405GPR-3KB266 Datasheet - Page 12

• Manufacturer Part Number: PPC405GPR-3KB266
• Manufacturer: Applied Micro Circuits Corporation

Specifications of PPC405GPR-3KB266

• Family Name: 405GPr
• Device Core: PowerPC
• Device Core Size: 32b
• Frequency (max): 266MHz
• Instruction Set Architecture: RISC
• Supply Voltage 1 (typ): 1.8V
• Operating Supply Voltage (max): 1.9V
• Operating Supply Voltage (min): 1.7V
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 456
• Package Type: EBGA
• Lead Free Status / RoHS Status: Compliant

405GPr – Power PC 405GPr Embedded Processor
Serial Interface
IIC Bus Interface
General Purpose IO (GPIO) Controller
12
• One 8-pin UART and one 4-pin UART interface provided
• Selectable internal or external serial clock to allow a wide range of baud rates
• Register compatibility with NS16550 register set
• Complete status reporting capability
• Transmitter and receiver are each buffered with 16-byte FIFOs when in FIFO mode
• Fully programmable serial-interface characteristics
• Supports DMA using internal DMA engine
• Compliant with Philips® Semiconductors I
• Operation at 100kHz or 400kHz
• 8-bit data
• 10- or 7-bit address
• Slave transmitter and receiver
• Master transmitter and receiver
• Multiple bus masters
• Supports fixed V
• Two independent 4 x 1 byte data buffers
• Fifteen memory-mapped, fully programmable configuration registers
• One programmable interrupt request signal
• Provides full management of all IIC bus protocol
• Programmable error recovery
• Controller functions and GPIO registers are programmed and accessed via memory-mapped OPB bus master
• 23 of 24 GPIOs are pin-shared with other functions. DCRs control whether a particular pin that has GPIO
• Each GPIO output is separately programmable to emulate an open-drain driver (i.e., drives to zero, three-
accesses
capabilities acts as a GPIO or is used for another purpose. The 23 GPIOs are multiplexed with:
stated if output bit is 1)
- 7 of 8 chip selects
- All 13 external interrupts
- All nine instruction trace pins
DD
IIC interface
2
C Specification, dated 1995
Revision 2.05 – March 24, 2008
Data Sheet
AMCC