SLFLD25-2GBJ STEC, SLFLD25-2GBJ Datasheet - Page 21

• Manufacturer Part Number: SLFLD25-2GBJ
• Manufacturer: STEC
• Type: Flash Driver

Specifications of SLFLD25-2GBJ

• Density: 2GByte
• Operating Supply Voltage (typ): 5V
• Operating Temperature (min): 0C
• Operating Temperature (max): 70C
• Package Type: Not Required
• Mounting: Screw
• Pin Count: 44
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 4.75V
• Operating Supply Voltage (max): 5.25V
• Programmable: Yes
• Lead Free Status / RoHS Status: Not Compliant

SLFLD25-xxxJ(I)
REVISION HISTORY
Rev. Change Description from Previous Revision
-101 2/1/04. Initial Release.
-102 5/26/04. IOL/IOH condition at 5.0V is removed.
-103 7/2/04. Pin Description changes: -IOIS16 not used in
-104 7/9/04. Endurance increased from 300,000 cycles min
-105 7/22/04. “up to” added to sustained read and write
-106 8/23/04. Environmental Characteristics updated to
-107 10/14/04. Standard ECC, Endurance, and Warranty
-108 2/14/05. Shock parameter changed to 0.330ms to
SimpleTech Inc. reserves the right to make changes to specifications and product descriptions such as but not limited to numbers,
parameters and other technical information contained herein without notice. Contact SimpleTech Inc. sales office to obtain the latest
specifications. SimpleTech Inc. grants no warranty with respect to this Data Sheet, neither explicit nor implied, and it is not liable for
direct or indirect damages. Some States do not grant the exclusion of incidental damages and as such this statement may not be valid in
such states. The provisions of this Data Sheet do not convey to the purchaser of the device any license under any patent rights or other
intellectual property rights of SimpleTech Inc. or others.
General Description updated with new marketing copy.
64MB removed. R/W speeds changed from 5.4/4.5MB/
s to 5/5MB/s. CHS Parameter table added. VCC 5V
tolerance changed to 5% from 10%. Disclaimer notice
added.
IDE mode; -IORDY description corrected to not used
by card and pulled up by 4.7K ohm resistor.
Performance rates for read and write described as
sustained read and sustained write. Error register bit
0 Function “not supported” phrase removed. DMA
commands removed (paper only error indicated that
DMA was supported). Identify Drive Information table
updated to reflect DMA not supported. DC
Characterists Sleep Mode value changed from 120uA
to 1200uA for 5V power supply.
to 2 million cycles min.
data rate performance.
testing parameters. Definition for Serial #, Firmware
Rev., and Model # in the Identify Drive Information
table added in callout. Words 4-5, 20-21, 49, and 63
of Drive ID table corrected.
bullets added to Features on page 1.
0.750ms from 11ms. 3/14/05. Humidity parameter
updated to 95% from 85%. CHS values updated.
Document Part Number 61000-02817-109 March 2005
IDE FLASH DRIVE
Page 21