SDINB11024 SanDisk, SDINB11024 Datasheet - Page 5

• Manufacturer Part Number: SDINB11024
• Manufacturer: SanDisk

Specifications of SDINB11024

• Lead Free Status / RoHS Status: Compliant

Revision 3.1
© 2006 SanDisk Corporation
1.2
1.3
1.4
Features
Document Scope
iNAND Standard
SanDisk iNAND product features include the following.
This document describes the key features and specifications of the SanDisk iNAND as well
as the information required to interface it to a host system. Chapter 2 describes the physical
and mechanical properties of iNAND, Chapter 3 contains the pins and register overview,
and Chapter 4 gives a general overview of the SD protocol. Information about SPI Protocol
can be referenced in Section 7 of the SDA Physical Layer Specification, Version 2.00.
SanDisk iNAND devices are fully compatible with the SDA Physical Layer Specification,
Version 2.00. This specification is available from the SD Card Association (SDA).
►Up to 4 GB of data storage
►SD-protocol compatible
►Supports SPI Mode
►Designed for portable and stationary applications that require high performance and reliable
►Voltage range 2.7 to 3.6V
► Variable clock rate 0-25 MHz (default), 0-50MHz (high-speed)
► Up to 25 MB/sec bus transfer rate (using 4 parallel data lines)
►Correction of memory-field errors
►Built-in write protection features (permanent and temporary)
►Application-specific commands
►Standard footprint across all capacities
SD Card Associations
2400 Camino Ramon, Suite 375
San Ramon, CA 94583 USA
Telephone: [phone]
Fax: [phone]
E-mail: [e-mail]
Website:
data storage
www.sdcard.org
1-2
SanDisk iNAND Product Manual
Chapter 1 – Introduction
12/07/06