LAN91C96-MU Standard Microsystems (SMSC), LAN91C96-MU Datasheet - Page 60
![](/photos/31/30/313088/100pin_tqfp_sml.jpg)
LAN91C96-MU
Manufacturer Part Number
LAN91C96-MU
Description
Manufacturer
Standard Microsystems (SMSC)
Datasheet
1.LAN91C96-MU.pdf
(125 pages)
Specifications of LAN91C96-MU
Operating Supply Voltage (typ)
3.3/5V
Operating Supply Voltage (min)
2.97V
Operating Supply Voltage (max)
5.5V
Operating Temperature Classification
Commercial
Mounting
Surface Mount
Pin Count
100
Lead Free Status / RoHS Status
Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
LAN91C96-MU
Manufacturer:
SMSC
Quantity:
1 430
Company:
Part Number:
LAN91C96-MU
Manufacturer:
Standard
Quantity:
2 701
Company:
Part Number:
LAN91C96-MU
Manufacturer:
Microchip Technology
Quantity:
10 000
Part Number:
LAN91C96-MU
Manufacturer:
SMSC
Quantity:
20 000
Notes:
Revision 1.0 (10-24-08)
For edge triggered systems, the Interrupt Service Routine should clear the Interrupt Mask Register, and only
enable the appropriate interrupts after the interrupt source is serviced (acknowledged).
TX EMPTY INT - Set if the TX FIFO goes empty, can be used to generate a single interrupt at the end of a
sequence of packets enqueued for transmission. This bit latches the empty condition, and the bit will stay
set until it is specifically cleared by writing the acknowledge register with the TX EMPTY INT bit set. If a
real time reading of the FIFO empty is desired, the bit should be first cleared and then read.
The TX_EMPTY MASK bit should only be set after the following steps:
a)
b)
TX INT - Set when at least one packet transmission was completed or any of the below transmit fatal
errors occurs:
1.
2.
3.
4.
The first packet number to be serviced can be read from the FIFO PORTS register. The TX INT bit is
always the logic complement of the TEMPTY bit in the FIFO PORTS register. After servicing a packet
number, its TX INT interrupt is removed by writing the Interrupt Acknowledge Register with the TX INT bit
set.
RCV INT - Set when a receive interrupt is generated. The first packet number to be serviced can be read
from the FIFO PORTS register. The RCV INT bit is always the logic complement of the REMPTY bit in the
FIFO PORTS register.
Receive Interrupt is cleared when RX FIFO is empty.
A packet is enqueued for transmission
The previous empty condition is cleared (acknowledged)
SQET - SQE Error
LOST CARR - Lost Carrier
LATCOL - Late Collision
16COL - 16 collisions
DATASHEET
Page 60
Non-PCI Single-Chip Full Duplex Ethernet Controller with Magic Packet
SMSC LAN91C96 5v&3v
Datasheet