1-1734261-0 TE Connectivity, 1-1734261-0 Datasheet - Page 2

• Manufacturer Part Number: 1-1734261-0
• Description: Conn High Performance Interconnect HDR 10 POS 1.25mm Solder RA SMD T/R
• Manufacturer: TE Connectivity
• Type: High Performance Interconnectr

Specifications of 1-1734261-0

• Pitch: 1.25 mm
• Number Of Rows: 1
• Number Of Contacts: 10
• Gender: HDR
• Contact Plating: Tin Over Nickel
• Termination Method: Solder
• Product Type: Connector
• Connector Type: Header
• Mount Angle: Right Angle
• Number Of Positions: 10
• Centerline (mm [in]): 1.25 [0.049]
• Locking Interface: Without
• Post Material: Phosphor Bronze
• Post Plating: Tin over Nickel
• Contact Type: Pin
• Contact Termination Type: Surface Mount
• Contact Base Material: Phosphor Bronze
• Contact Finish: Tin over Nickel
• Connector Style: Plug
• Housing Color: Natural
• Ul Flammability Rating: UL 94V-0
• Housing Material: High Temperature Thermoplastic
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Reflow solder capable to 245°C, Reflow solder capable to 260°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Packaging Method: 24mm Tape & Reel
• Packaging Quantity: 1,000/Reel

1
2
3
4
5
7
8
6
Rev
3.4. PERFOMANCE AND TEST DESCRIPTION
3.5. TEST REQUIREMENTS AND PROCEDURES SUMMARY
C.
The product is designed to meet the electrical, mechanical and environmental performance requirements
specified in Figure 1 unless otherwise specified. All tests are performed at ambient environmental
conditions per AMP Specification 109-1
Connector Unmating Force 0.1 kgf/pin Min.
Connector Mating Force
Examination of Product
Termination Resistance
Dielectric withstanding
Insulation Resistance
C
Temperature Rising
Temperature: -25 °C to 85°C
Durability
Test Item
Voltage
Meets requirements of product
drawing. No physical damage.
20 m Max
1000 M Min. (Initial)
100 M Min. (Finial)
No creeping discharge nor
flashover shall occur.
Current leakage: 0.5 mA MAX
30C° Max. under loaded rating
current
1 kgf/pin Max.
See note.
Mechanical Requirement
Electrical Requirement
Requirement
Figure 1 (cont.)
Subject mated contacts assembled in
housing to 20mV Max open circuit at
10mA Max.
Impressed voltage 500 VDC
Test between adjacent circuits and
contact
500 VAC for 1minute
Test between adjacent circuits and
contact
Contact series-wired, apply test current
of loaded rating current to the circuit,
and measure the temperature rising by
probing on soldered areas of contacts,
after the temperature becomes
stabilized deduct ambient temperature
from the measured value.
Operation Speed: 10 mm/min.
Measure the force required to mate
connector
Operation Speed: 10 mm/min.
Measure the force required to unmate
connector
Operation Speed: 10 cycle/min.
No. of Cycles: 25 Cycles
Visual inspection
Procedure
108-57273
2 of 4