SFELF10M7JAA0-B0 Murata Electronics, SFELF10M7JAA0-B0 Datasheet - Page 72

• Manufacturer Part Number: SFELF10M7JAA0-B0
• Description: Electromechanical Filter 150KHz
• Manufacturer: Murata Electronics

Specifications of SFELF10M7JAA0-B0

• 3db Bandwidth: 150 KHz

19
!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
1. Standard Reflow Soldering Conditions
(1) Reflow
(2) Soldering Iron
2. Wash
(1) Cleaning Solvent
(2) Cleaning Conditions
(3) Notice
The component cannot withstand washing.
70
Notice (Soldering and Mounting)
CERAFILr 455kHz Chip Type SFPKA Series
CERAFILr 455kHz Lead Type
Filter is soldered twice within the following temperature
conditions.
Electrode is directly soldered with the tip of soldering iron
at +350 5 C for 3.0 0.5 seconds.
CFC alternatives (HCFC Series), Isopropyl Alcohol (IPA),
Water (Demineralized Water), Cleaning Water Solution
(Cleanthrough-750H, Pine Alpha 100S), Silicon
(Technocare FRW)
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Immersion Wash
2 minutes max. in above solvent at +60 C max.
Shower or Rinse Wash
2 minutes max. in above solvent at +60 C max.
When components are immersed in solvent, be sure to
maintain the temperature of components below the
temperature of solvent.
Please do not use ultrasonic cleaning.
Total washing time should be within 4 minutes.
Please ensure the component is thoroughly evaluated
in your application circuit.
Please do not use chlorine, petroleum and alkaline
cleaning solvents.
If you plan to use any other type of solvents, please
consult with Murata or Murata representative prior to
using.
260
230
100
30 sec.
min.
(150-180 C)
Pre-heating
60-120 sec.
(260 C max.)
Heating
(230 C)
40 sec.
Peak
max.
Gradual
Cooling
120 sec.
min.
P50E.pdf
10.2.9