STLC2416 STMicroelectronics, STLC2416 Datasheet - Page 13

• Manufacturer Part Number: STLC2416
• Description: Bluetooth Class I 1.8V 0.721Mbps 120-Pin LFBGA
• Manufacturer: STMicroelectronics

Specifications of STLC2416

• Package: 120LFBGA
• Power Class: Class I
• Maximum Data Rate: 0.721 Mbps
• Operating Supply Voltage: 1.8 V
• Lead Free Status / Rohs Status: Not Compliant

– Vdd Supply Voltage (vddf)
– Vddq Supply Voltage (vddq)
– Vpp Program Supply Voltage (vpp)
– Vssf Flash Ground (vssf)
– Address Inputs (Addr(1-18)/Addr(0-19)), Data Input/Output (Data(0-15)/Data(0-15)), Chip Enable (ne/
the device enters read array mode, but a negative transition of Chip Enable or a change of the address
is required to ensure valid data outputs.
Vdd provides the power supply to the internal core of the flash memory device. It is the main power sup-
ply for all operations (Read, Program and Erase)
Vddq provides the power supply to the I/O pins and enables all Outputs to be powered independently
from Vddf. Vddq can be tied to Vddf or can use separate supply.
Vpp is both a control input and a power supply pin. The two functions are selected by the voltage range
applied to the pin. The supply voltage Vddf and the program supply voltage Vpp can be applied in any
order.
If Vpp is kept in a low voltage range (0V to 3.6V) Vpp is seen as a control input. In this case a voltage
lower than 1V gives protection agains program or block erase, while 1.65V<Vpp<3.6V enables these
functions. Vpp is only sampled at the beginning of a program or block erase; a change in its value after
the operation has started does not have any effect and program or erase operations continue.
If Vpp is in the range 11.4V to 12.6V it acts as a power supply pin. In this condition Vpp must be stable
until the Program/Erase algorithm is completed.
Vssf is the reference for all voltage measurements.
csn(0)), Output Enable (ng/rdn), Write Enable (nw/wrn) are connected to and controlled by the Blue-
tooth™ baseband controller.
STLC2416
13/27