PKL4110PITLA Ericsson Power Modules, PKL4110PITLA Datasheet - Page 37

• Manufacturer Part Number: PKL4110PITLA
• Description: DC/DC CONVERTER
• Manufacturer: Ericsson Power Modules

Specifications of PKL4110PITLA

• Package: 11Half-Brick

Soldering Information — Through hole mounting
The PKL series DC/DC converters are intended for through
hole mounting in a PCB. When wave soldering is used max
temperature on the pins is specified to 260°C for 10 seconds.
Maximum preheat rate of 4°C/s and temperature of max
150°C is suggested. When hand soldering, care should be
taken to avoid direct contact between the hot soldering iron
tip and the pins for more than a few seconds in order to
prevent overheating.
No-clean flux is recommended to avoid entrapment of
cleaning fluids in cavities inside of the DC/DC power module.
The residues may affect long time reliability and isolation
voltage.
Delivery package information
The products are delivered antistatic clamshells.
Prepared (also subject responsible if other)
EPANHON
Approved
SEC/D (Linda zhong)
PKL 4000 PI series
DC/DC converters, Input 36-75 V, Output 100 A/300 W
Tray properties
Material
Surface resistance
Bake ability
Clamshell capacity
Box capacity
PET
10E5 to 10E12 ohms/square
The clamshells can not be baked
10 converters/clamshell
50 converters (5 full clamshells/box)
Checked
(MICKAOV)
PRODUCT SPECIFICATION
No.
4/1301-BMR 632
Date
2006-1-26
Technical Specifi cation
EN/LZT 146 311 R2E June 2007
© Ericsson Power Modules AB
Rev
B
Reference
2 (4)
37