88013K NEWPORT ELECTRONICS, 88013K Datasheet - Page 33

• Manufacturer Part Number: 88013K
• Description: Test Probe
• Manufacturer: NEWPORT ELECTRONICS

Specifications of 88013K

• Test Probe Functions: Temperature
• For Use With: OS530, OS520 Series Handheld Infrared Thermometer
• Lead Free Status / RoHS Status: na

2-18
ATC
2
°F
2.3.9 Sending Temperature Data to a Serial Printer
PRN
Using the Handheld Infrared Thermometer
°F
(OS533, OS534, OS523, OS524)
The thermometer can transmit temperature data to a Serial
Printer via the RS-232 phone jack and the RS-232 cable.
8.
9.
10.
11.
1.
2.
Press and hold the
Mode (E) appears.
Change the emissivity to the proper value for the target
being measured (refer to Section 2.3.1).
Aim at the target. The target temperature and emissivity
are displayed on the LCD.
After all data is taken, press the
this mode
Turn on the Serial Printer and set the following
parameters:
Connect the RS-232 cable between the thermometer and
the printer as shown in Figure 2-14.
Speed: 4800 BPS
Data:
The target ambient temperature does not change
when the thermometer is turned off. However,
when the batteries are replaced, it is reset to the
default value of 75°F.
To disable the Ambient Target Temperature
Compensation at a later time, you must press the
Temperature Display Mode. Then press the
key to disable it.
key to get into the Ambient Target
8 Bits
NOTE
key until the Emissivity Display
NOTE
One Stop Bit
No Parity
key to release