12211 Simpson, 12211 Datasheet - Page 2

• Manufacturer Part Number: 12211
• Description: MULTIMETER, ANALOG, 7 FUNCTIONS
• Manufacturer: Simpson

Specifications of 12211

• Voltage Measuring Range Dc: 250mV To 1000V
• Voltage Measuring Range Ac: 2.5V To 1000V
• Current Measuring Range Dc: 50µA To 5A
• Current Measuring Range Ac: 250A
• Range Selection: Manual
• Accuracy: +/- 2 %
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

About this Manual
To the best of our knowledge and at the time written, the information contained in
this document is technically correct and the procedures accurate and adequate to
operate this instrument in compliance with its original advertised specifications.
Notes and Safety Information
This Operator’s Manual contains warning headings which alert the user to check
for hazardous conditions. These appear throughout this manual where applicable,
and are defined below. To ensure the safety of operating performance of this in-
strument, these instructions must be adhered to.
!
Warning, refer to accompanying documents.
Caution, risk of electric shock.
!
This instrument is designed to prevent accidental shock to the operator when
properly used. However, no engineering design can render safe an instrument
whick is used carelessly. Therefore, this manual must be read carefully and com-
pletely before making any measurements. Failure to follow directions can result in
ser ious or fatal accident.
Shock Hazard: As defined in American National Standard, C39.5, Safety
Requrements for Electrical and Electronic Measuring and Controlling Instrumen-
tation, a shock hazard shall be considered to exist at any part involving a potential
in excess of 30 volts RMS (sine wave) or 42.4 volts DC or peak and where a
leakage current from that part to ground exceeds 0.5 milliampere, when mea-
sured with anappropriate measuring instrument defined in Section 11.6.1 of ANSI
C 39.5.
Technical Assistance
SIMPSON ELECTRIC COMPANY offers assistance Monday through Friday
7:30 am to 5:00 pm Central Time by contacting Technical Support or
Customer Service at [phone].
Internet: http://www.simpsonelectric.com
Warranty and Returns
SIMPSON ELECTRIC COMPANY warrants each instrument and other articles
manufactured by it to be free from defects in material and workmanship under
normal use and service, its obligation under this warranty being limited to making
good at its factory or other article of equipment which shall within one (1) year
after delivery of such instrument or other article of equipment to the original pur-
chaser be returned intact to it, or to one of its authorized service centers, with
transportation charges prepaid, and which its examination shall disclose to its
satisfaction to have been thus defective; this warranty being expressly in lieu of all
other warranties expressed or implied and of all other obligations or liabilities on
its part, and SIMPSON ELECTRIC COMPANY neither assumes nor authorizes
any other persons to assume for it any other liability in connection with the sales of
its products.
This warranty shall not apply to any instrument or other article of equipment which
shall have been repaired or altered outside the SIMPSON ELECTRIC COMPANY
factory or authorized service centers, nor which has been subject to misuse, neg-
ligence or accident, incorrect wiring by others, or installation or use not in accord
with instructions furnished by the manufacturer.
260
®
is a Registered Trademark of the Simpson Electric Company.
2