M4SSER OPTO 22, M4SSER Datasheet - Page 4

• Manufacturer Part Number: M4SSER
• Description: Computers, Serial Interface Cards
• Manufacturer: OPTO 22

Specifications of M4SSER

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

DATA SHEET
Form 664-070104
Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • Phone: [phone] • (800) 321-OPTO • Fax: [phone] • www.opto22.com
Installation
Before installing the M4SSER into the M4 Modular Controller expansion slot, make sure all jumpers have been properly set for RS-232 or RS-485/422
communications. Then follow the instructions below:
1. Remove all power from the M4 Modular Controller.
2. Remove the blank end cap for any of the three M4BUS expansion slots, located below the serial I/O connectors. Each end cap is held in place by two screws located
3. Align the edges of the M4SSER with the selected expansion slot U-channels located on the sides of the expansion bus cavity. Slide the card all the way in until it
4. Use the original screws to attach the new end cap (included with the M4SSER) to the end of the M4 Modular Controller unit.
5. Only one M4SSER may be added to an M4 controller.
on the side panel, adjacent to each end cap. (You may also need to remove one or two additional end caps to achieve proper card alignment.)
seats into the M4BUS connector.
Inside Sales: (800) 321-OPTO • Product Support: (800) TEK-OPTO • [phone] • Fax: [phone] • E-mail: [e-mail]
INTERFACES
CONTROLLER
MODULAR
page 4/7