D01627 DURATOOL, D01627 Datasheet

no-image

D01627

Manufacturer Part Number
D01627
Description
WIRE STRIPPER, 0.08 - 6 MM2
Manufacturer
DURATOOL
Datasheet
1.D01626.pdf (2 pages)

Specifications of D01627

Stripping Capacity
6mm2
Svhc
No SVHC (15-Dec-2010)
Colour
Black / Red
Stripping Capacity Awg
10AWG
For Use With
Solid & Stranded Wires
Lead Free Status / RoHS Status
na
D01626
Description
The D01626 a semi automatic wire stripping tool incorporating a flexible jaw cutting edge consisting of a large number of independent
leaf blades on as resilient base. These blades surround each conductor by self adjustment thus reducing conductor damage. By
using a flexible jaw principle, single, round or flat wires may be stripped with ease. The tool will strip wires up to #15AWG (1.5mm
overall cross-section. Make adjustments using the small screw driver supplied.
Stripping depth adjuster
For the normal range of wires the depth adjusting screw (1) should be advanced 3/4 turn (clockwise) from its maximum retracted
position (retraction counterclock wise is captivated). Deeper or shallower penetration of insulation is achieved by turning the screw
accordingly. Optimize its position so that conductors are not damaged.
Gripping jaw inserts
Select jaw inserts (2) according to the gripping surface required.
Red pads
Green pads
White pads
For very delicate and thin insulations use the white pads.
Stripping and cutting
1. To strip, hold the wire inside the jaws up to the stop (3) and squeeze the handle.
2. A cutting blade (4) is provided for wire cropping, fully shielded to protect the operator.
Stripping jaw replacement
1. Remove black cover cap (5) and extract the jaw pivot pin (6).
2. Pull out moving jaw holder (7).
3. Remove old stripping jaws by pulling out the holding rivet within.
4. Replace with new jaws and reverse-instructions for re-assembly.
Ultrasonic Cleaning
: Coarse gripping
: Medium gripping
: fine gripping
Page <1>
14/10/09 V1.0
2
)

D01627 Summary of contents

Page 1

Ultrasonic Cleaning D01626 Description The D01626 a semi automatic wire stripping tool incorporating a flexible jaw cutting edge consisting of a large number of independent leaf blades on as resilient base. These blades surround each conductor by self adjustment thus ...

Page 2

... Operation Once set for the required cable size, the cable is inserted into the jaws of the tool and [he handles squeezed together. The D01627 will grip and strip the cable in one action; to release simply relax the grip on the tool at the end of the cycle. Where longer strip lengths are required, the cable may be allowed to protrude from the side of the jaws prior to stripping ...