ES-FA-6G BANNER ENGINEERING, ES-FA-6G Datasheet - Page 10

• Manufacturer Part Number: ES-FA-6G
• Description: ES-FA-6G SINGLE OUTPUT E-STOP
• Manufacturer: BANNER ENGINEERING

Specifications of ES-FA-6G

• Relay Mounting: DIN Rail
• Peak Reflow Compatible (260 C): No
• Coil Voltage Vdc Nom: 24V
• External Width: 22.5mm
• Contact Voltage Ac Nom: 250V
• External Depth: 118.2mm
• Coil Voltage Vac Nom: 24V
• Contact Current Max: 6A
• Contact Voltage Dc Nom: 250V
• External Height: 82mm

E-Stop Safety Module
page
Supply Voltage and Current
Supply Protection Circuitry
Output Configuration
Output Response Time
Input Requirements
Status Indicators
Housing
Mounting
Vibration Resistance
Operating Conditions
Dimensions
10
24V ac/dc, +/- 10%; 50/60Hz
Power consumption: approx. 2W/0.75VA
Protected against transient voltages and reverse polarity
Outputs (K1 & K2):
Contact ratings:
NOTE: Transient suppression is recommended when switching inductive loads. Install suppressors
across load. Never install suppressors across output contacts (see Warning, page 5).
35 milliseconds typical
E-stop switch must have a normally closed contact capable of switching 40 to 100mA @ 13 to 27V ac/dc.
Reset switch must have one normally open contact capable of switching 20 to 30mA @ 13 to 27V ac/dc.
3 green LED indicators:
Power ON
K1 energized
K2 energized
Polycarbonate. Rated NEMA 1; IEC IP40, Terminals IP20
Mounts to standard 35 mm DIN rail track. Safety Module must be installed inside an enclosure rated NEMA 3
(IEC IP54), or better.
10 to 55Hz @ 0.35mm displacement per IEC 68-2-6
Temperature:
Maximum Relative Humidity: 90% @ +50°C (non-condensing)
See Figure 4.
Maximum voltage: 250V ac or 250V dc
Maximum current: 6 A ac or dc
Minimum current: 30 mA @ 10V dc
Maximum power: 1500VA, 150W
Mechanical life: 10,000,000 operations
Electrical life: 100,000 at full resistive load
E-Stop Safety Module Product Specifications
– Model ES-FA-6G
three redundant (total of six) safety relay (forced-guided) contacts – AgSnO
one auxiliary non-safety monitor output (open when both K1 and K2 are energized;
closed when either K1 or K2 are de-energized)
0° to +50°C (+32° to 122°F)
2