CMH07(TE12L,Q) Toshiba, CMH07(TE12L,Q) Datasheet - Page 2

• Manufacturer Part Number: CMH07(TE12L,Q)
• Description: DIODE HI EFF 200V 2A M-FLAT
• Manufacturer: Toshiba

Specifications of CMH07(TE12L,Q)

• Voltage - Forward (vf) (max) @ If: 980mV @ 2A
• Voltage - Dc Reverse (vr) (max): 200V
• Current - Average Rectified (io): 2A
• Current - Reverse Leakage @ Vr: 10µA @ 200V
• Diode Type: Standard
• Speed: Fast Recovery =< 500ns, > 200mA (Io)
• Reverse Recovery Time (trr): 35ns
• Mounting Type: Surface Mount
• Package / Case: 3-4E1A (M-Flat)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Capacitance @ Vr, F: -

Marking
Standard Soldering Pad
Handling Precaution
The maximum ratings denote the absolute maximum ratings, which are rated values and must not be exceeded during
operation, even for an instant. The following are the general derating methods that we recommend when you design a
circuit with a device.
VRRM: We recommend that the worst case voltage, including surge voltage, be no greater than 80% of the maximum
IF(AV): We recommend that the worst case current be no greater than 80% of the maximum rating of IF(AV). Carry out
This rating specifies the non-repetitive peak current in one cycle of a 50-Hz sine wave, condition angle 180. Therefore,
this is only applied for an abnormal operation, which seldom occurs during the lifespan of the device.
We recommend that a device be used at a Tj of below 120℃ under the worst load and heat radiation conditions.
Thermal resistance between junction and ambient fluctuates depending on the device’s mounting condition. When using
a device, design a circuit board and a soldering land size to match the appropriate thermal resistance value.
Please refer to the Rectifiers databook for further information.
Abbreviation Code
rating of VRRM for a DC circuit and be no greater than 50% of that of VRRM for an AC circuit.
VRRM has a temperature coefficient of 0.1%/℃. Take this temperature coefficient into account designing a device
at low temperature.
adequate heat design. If you can’t design a circuit with excellent heat radiation, set the margin by using an
allowable Tamax-IF (AV) curve.
H7
1.4
3.0
Part No.
CMH07
1.4
Unit: mm
2
2004-07-01
CMH07