E2C-ED01 Omron, E2C-ED01 Datasheet - Page 15

• Manufacturer Part Number: E2C-ED01
• Description: Smart Prox Sensor
• Manufacturer: Omron
• Series: E2Cr

Specifications of E2C-ED01

• Maximum Operating Temperature: + 60 C
• Supply Voltage: 12 V to 24 V
• Mounting Style: DIN Rail
• Sensing Distance: 1 mm
• Minimum Operating Temperature: - 10 C
• Sensor Type: Inductive
• Sensing Object: Metallic
• Response Frequency: -
• Material - Body: Stainless Steel
• Shielding: Shielded
• Voltage - Supply: -
• Output Type: -
• Terminal Type: Connector
• Package / Case: Cylinder, Threaded
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Precautions
Precautions for Correct Use
Do not use this product in operating atmospheres or environments
outside the specified ratings.
Amplifier Units
● Design
Power ON
The Sensor is ready to sense an object within 200 ms after turning
the power ON. If the load and Sensor are connected to different
power supplies, always turn ON the Sensor power first.
● Connecting Sensor Heads
Connecting and Disconnecting Sensor Heads
1. Open the protective cover.
2. Making sure that the lock button is up, insert the fibers all the way
To disconnect the Sensor Head, pull out the fibers while pressing on
the lock button.
Connecting and Disconnecting Connectors
Connecting Connectors
1. Insert the Master or Slave Connector into the Amplifier Unit until it
2. Apply the supplied seal to the non-connection surface of the Mas-
Note: Apply the seal to the grooved side.
Do not use this product in any safety device used for the
protection of human lives.
to the back of the Connector insertion opening.
clicks into place.
ter/Slave Connector.
2
1
Lock button
!WARNING
Power supply Connector
Protector seal
Insert
E2C-EDA
Disconnecting Connectors
1. Slide the Slave Amplifier Unit.
2. After the Amplifier Unit has been separated, press down on the
Installing and Removing Amplifier Units
Installing Amplifier Units
1. Install the Units one by one to the DIN rail.
2. Slide one Unit toward the other, match the clips at the front ends,
Removing Amplifier Units
Slide one Unit away from the other and remove them one by one.
(Do not remove the connected Units together from the DIN rail.)
End Plate Mounting (PFP-M)
Mount End Plates on Amplifier Units to avoid movement due to
vibration. When a Mobile Console is installed, mount the End Plate
facing as shown in the following diagram.
Note 1. When the Amplifier Units are connected to each other, the
Sensor Head Connector Clips
lever on the Connector and remove it. (Do not attempt to remove
Connectors without separating them from other Amplifier Units
first.)
and then bring them together until they “click.”
High-resolution Digital Proximity Sensor
2. Before connecting or disconnecting the Units, always switch
operable ambient temperature changes depending on the
number of connected Amplifier Units. Check Specifications.
power OFF.
DIN rail
End Plate
2
1
2
Press down.
DIN rail
1
1
Remove
Lever
15