DCN4-BR4 Omron, DCN4-BR4 Datasheet - Page 89
DCN4-BR4
Manufacturer Part Number
DCN4-BR4
Description
Std. Flat Cbl Branch Line Pres
Manufacturer
Omron
Datasheet
1.XW4B-05C4-TF-D.pdf
(166 pages)
Specifications of DCN4-BR4
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
- Current page: 89 of 166
- Download datasheet (4Mb)
Wiring Methods
2-4-3
68
Attaching Shielded Connectors
1,2,3...
Note Use the OMRON XW4Z-00B Screwdriver to tighten the line set screws of the
Use the following procedure to attach shielded connectors to the communica-
tions cables. This section explains the basic attachment procedure. For more
details on connector assembly methods, refer to XS2 in the Sensor I/O Con-
nectors Catalog (G05) (The connectors used for DeviceNet communications
cables use screws to secure the wires.)
1. Insert the cable into the cap, cable clamp, water-tight bushing, and cover.
2. Prepare the communications cable, referring to the procedure described
3. When using shielded connectors, remove approximately 20 mm of the ca-
4. Insert the signal lines, power lines and shield wire into the contact block
5. Tighten the contact block’s line set screws on each of the lines. Tighten the
shielded connector for custom cable assembly.
3. After attaching the cable, confirm that it is properly pressure-welded as
under Attaching Communications Cables in 2-4-1 Wiring and Installing
Standard Connectors.
ble covering, and strip approximately 8 mm of the sheath from the signal
lines and power lines (refer to the following diagram). Do not remove too
much of the covering. Removing excessive cable covering may result in a
short circuit or the expected water-tight capabilities will not be provided.
holes, making sure the terminal numbers are correct.
set screws to a torque of between 0.15 and 0.2 N ⋅ m using a special screw-
driver.
shown below.
There should be no gaps here.
Section 2-4
Related parts for DCN4-BR4
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Multi-Wiring Connector
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
Terminal Block Adaptor
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
Std. Flat Cbl Conn Terminating
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
Std. Flat Cbl Trunk Line Press
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
Thin Cable-Flat Cable Conv Con
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
Cabl PwrSupTrmBlk W/ TrmResist
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
DeviceNet Flat Cable Connector
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
NonUL Multidrop Flat Connector
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
G6S-2GLow Signal Relay
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Compact, Low-cost, SSR Switching 5 to 20 A
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet: