DCN4-BR4 Omron, DCN4-BR4 Datasheet - Page 83
DCN4-BR4
Manufacturer Part Number
DCN4-BR4
Description
Std. Flat Cbl Branch Line Pres
Manufacturer
Omron
Datasheet
1.XW4B-05C4-TF-D.pdf
(166 pages)
Specifications of DCN4-BR4
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
- Current page: 83 of 166
- Download datasheet (4Mb)
Wiring Methods
2-4
2-4-1
Attaching
Communications
Cables
62
Wiring Methods
Wiring and Installing Standard Connectors
1,2,3...
Note The current capacity of thick cable is 8 A, so up to 16 A can be supplied to the
network by supplying communications power in two directions from the power
supply through thick cables.
The current capacity of thin cable is limited to 3 A. Up to 6 A can be supplied
to the network when communications power is supplied in two directions from
the power supply through thin cables.
If a thin cable is connected in one direction and a thick cable is connected in
the other, the maximum current is 3 A + 8 A = 11 A total.
Use the following procedure to prepare and connect the communications
cables to the connectors.
1. Strip about 30 mm of the cable sheathing, being careful not to damage the
2. Carefully peel back the woven shield. There is a bare shield wire under the
3. Cut away the exposed woven shield, remove the aluminum tape from the
Ambient humidity
Surge current capacity
woven shield just below the sheathing. Do not remove more than about
30 mm; removing too much of the covering can result in short circuits or
allow noise into the Network.
woven shield as well as the signal lines and power lines. (The shield wire
will be loose on the outside of the other lines, but it is stiffer than the woven
shield and easy to identify by touch.)
signal and power lines, and strip the sheath from the signal and power lines
to the proper length for the crimp terminal connectors. Twist together the
stranded wires of each signal and power lines.
Item
Approx. 30 mm
Strip proper length for
the terminals being used.
30% to 90% (with no condensation)
10% max.
Shield wire
Specifications
Section 2-4
Related parts for DCN4-BR4
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Multi-Wiring Connector
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
Terminal Block Adaptor
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
Std. Flat Cbl Conn Terminating
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
Std. Flat Cbl Trunk Line Press
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
Thin Cable-Flat Cable Conv Con
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
Cabl PwrSupTrmBlk W/ TrmResist
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
DeviceNet Flat Cable Connector
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
NonUL Multidrop Flat Connector
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
G6S-2GLow Signal Relay
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Compact, Low-cost, SSR Switching 5 to 20 A
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet: