MTCBA-G2-EN2-GP Multi-Tech Systems, MTCBA-G2-EN2-GP Datasheet - Page 11

• Manufacturer Part Number: MTCBA-G2-EN2-GP
• Description: ROUTER WIRELESS QUAD GPRS GPS
• Manufacturer: Multi-Tech Systems
• Series: MultiModem® rCellr

Specifications of MTCBA-G2-EN2-GP

• Function: Transceiver, GPRS, Router
• Modulation Or Protocol: GSM, GPRS
• Frequency: 850MHz, 900MHz, 1.8GHz, 1.9GHz, 1575.42MHz
• Applications: General Purpose
• Interface: RJ-45, RS-232
• Sensitivity: -161dB
• Voltage - Supply: 9 V ~ 32 V
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 881-1087

for remote configuration, you need to ensure that your wireless
network provider has provisioned mobile terminated data and fixed or
dynamic public IP address in which they can configure the network to
redirect any incoming connection to that predefined IP.
Verifying Signal Strength
Note:
ready. Ensure that PPP is disabled before verifying signal strength.
Checking Network Registration and Roaming
Status
Verify that the Router has been registered on the wireless network. Using
HyperTerminal, type AT+GREG? for most models. The MTCBA-EV2-EN2
does not support this command, see the Note below for an alternative
method.
Multi-Tech Systems, Inc. Quick Start Guide
Note:
1.
2.
3.
1.
2.
To Telnet to the modem. You can access the modem thru the Run
icon or from the Command Prompt:
In the command window, type AT+CSQ
The router responds with the received signal strength (rssi) and the
channel bit error rate (ber).RSSI ranges from 0 to 31. BER ranges
from 0 to 7 (7 is the highest error rate).
In the command window, type AT+CREG?
The router will respond in one of the following ways:
Ensure that the Status LED is blinking, indicating that the router is
If you need remote access to your MultiModem over the internet
Click Start I Run icon. In the Open window, enter cmd and then
press ENTER.
Click Start I All Programs I Accessories I Command Prompt
●
●
●
Signal Strength – RSSI
10 – 31
0 – 9
99
At the Login prompt, type the default user name: admin (all
lower-case). Press ENTER
At the Password prompt, type the default pass word: admin (all
lower-case). Press ENTER
In the command window, type telnet 192.168.2.1 5000
Sufficient
Weak or Insufficient
Insufficient
MultiModem rCell Intelligent Wireless Router
or
11