CS4384-CQZR Cirrus Logic Inc, CS4384-CQZR Datasheet - Page 49

• Manufacturer Part Number: CS4384-CQZR
• Description: IC - 192kHz 6and8 Channel D/A Conv
• Manufacturer: Cirrus Logic Inc

Specifications of CS4384-CQZR

• Number Of Bits: 24
• Data Interface: Serial
• Number Of Converters: 8
• Voltage Supply Source: Analog and Digital
• Power Dissipation (max): 520mW
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 48-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1525 - BOARD EVAL FOR CS4384 DAC
• Settling Time: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

DS620F1
8. REFERENCES
9. PARAMETER DEFINITIONS
Total Harmonic Distortion + Noise (THD+N)
Dynamic Range
Interchannel Isolation
Interchannel Gain Mismatch
Gain Error
Gain Drift
1. How to Achieve Optimum Performance from Delta-Sigma A/D & D/A Converters, by Steven Harris. Paper
2. CDB4364 data sheet, available at http://www.cirrus.com.
3. Design Notes for a 2-Pole Filter with Differential Input, by Steven Green. Cirrus Logic Application Note AN48
4. The
5. AN282 “The 2-Channel Serial Audio Interface: A Tutorial”
presented at the 93rd Convention of the Audio Engineering Society, October 1992.
http://www.semiconductors.philips.com
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels.
The ratio of the full-scale rms value of the signal to the rms sum of all other spectral components over the
specified bandwidth. Dynamic range is a signal-to-noise measurement over the specified bandwidth made
with a -60 dBFS signal. 60 dB is then added to the resulting measurement to refer the measurement to full
scale. This technique ensures that the distortion components are below the noise level and do not affect the
measurement. This measurement technique has been accepted by the Audio Engineering Society, AES17-
1991, and the Electronic Industries Association of Japan, EIAJ CP-307.
A measure of crosstalk between the left and right channels. Measured for each channel at the converter's
output with all zeros to the input under test and a full-scale signal applied to the other channel. Units in deci-
bels.
The gain difference between left and right channels. Units in decibels.
The deviation from the nominal full-scale analog output for a full-scale digital input.
The change in gain value with temperature. Units in ppm/°C.
I²C
-Bus Specification: Version 2.0, Philips Semiconductors, December 1998.
CS4384
49