CS4265-DNZR Cirrus Logic Inc, CS4265-DNZR Datasheet - Page 26

• Manufacturer Part Number: CS4265-DNZR
• Description: IC,Soundcard Circuits,LLCC,32PIN,PLASTIC
• Manufacturer: Cirrus Logic Inc
• Type: Stereo Audior

Specifications of CS4265-DNZR

• Data Interface: Serial
• Resolution (bits): 24 b
• Number Of Adcs / Dacs: 2 / 2
• Sigma Delta: Yes
• Dynamic Range, Adcs / Dacs (db) Typ: 104 / 104
• Voltage - Supply, Analog: 3.13 V ~ 5.25 V
• Voltage - Supply, Digital: 3.13 V ~ 5.25 V
• Operating Temperature: -40°C ~ 105°C
• Mounting Type: Surface Mount
• Package / Case: 32-QFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1001 - BOARD EVAL FOR CS4265 CODEC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

26
4.4
4.5
4.5.1
Analog Input Multiplexer, PGA, and Mic Gain
The CS4265 contains a stereo 2-to-1 analog input multiplexer followed by a programmable gain amplifier
(PGA). The input multiplexer is able to select either a line-level input source, or a mic-level input source, and
route it to the PGA. The mic-level input passes through a +32 dB gain stage prior to the input multiplexer,
allowing it to be used for microphone-level signals without the need for any external gain. The PGA stage
provides 12 dB of gain or attenuation in 0.5 dB steps.
plexer, PGA, and mic gain stages.
The
tiplexer and mic gain.
Address 08h” on page 39
level input is selected by the input multiplexer, and the PGA is set to 0 dB.
Input Connections
The analog modulator samples the input at 6.144 MHz (MCLK=12.288 MHz). The digital filter will reject sig-
nals within the stopband of the filter. However, there is no rejection for input signals which are
(n
for the recommended analog input circuit that will attenuate noise energy at 6.144 MHz. The use of capac-
itors which have a large voltage coefficient (such as general-purpose ceramics) must be avoided since
these can degrade signal linearity. Any unused analog input pairs should be left unconnected.
Pseudo-Differential Input
The CS4265 implements a pseudo-differential input stage. The SGND input is intended to be used as a
pseudo-differential reference signal. This feature allows for common mode noise rejection with single-
ended signals.
ferential input stage. The Typical Connection Diagram shows the recommended pseudo-differential input
×
““Analog Input Selection (Bit 0)” on page
6.144 MHz) the digital passband frequency, where n=0,1,2,... Refer to the Typical Connection Diagram
Figure 12
“Channel B PGA Control - Address 07h” on page 39
outline the register settings necessary to control the PGA. By default, the line-
MICIN1
MICIN2
shows a basic diagram outlining the internal implementation of the pseudo-dif-
AINA
AINB
Figure 11. Analog Input Architecture
+32 dB
+32 dB
Selection Bits
Analog Input
MUX
MUX
40” outlines the bit settings necessary to control the input mul-
PGA Gain Bits
PGA Gain Bits
Channel A
Channel B
PGA
PGA
Figure 11
Out to ADC
Channel B
Out to ADC
Channel A
shows the architecture of the input multi-
and
“Channel A PGA Control -
CS4265
DS657F2