A1152LLHLT-T Allegro Microsystems Inc, A1152LLHLT-T Datasheet - Page 8

• Manufacturer Part Number: A1152LLHLT-T
• Description: 2-Wire Factory Programmed Switch
• Manufacturer: Allegro Microsystems Inc
• Type: Unipolar Switchr

Specifications of A1152LLHLT-T

• Sensing Range: 110G Trip, 45G Release
• Voltage - Supply: 3 V ~ 24 V
• Current - Supply: 6.9mA
• Output Type: Digital, Open Collector
• Features: High Speed
• Operating Temperature: -40°C ~ 150°C
• Package / Case: SOT-23W
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Output (max): -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 620-1378-2

A1152, A1153,
A1155, and A1156
Figure 2. Typical application circuits
Chopper Stabilization Technique
When using Hall-effect technology, a limiting factor for
switchpoint accuracy is the small signal voltage developed
across the Hall element. This voltage is disproportionally small
relative to the offset that can be produced at the output of the
Hall sensor IC. This makes it difficult to process the signal while
maintaining an accurate, reliable output over the specified oper-
ating temperature and voltage ranges. Chopper stabilization is
a unique approach used to minimize Hall offset on the chip. The
patented Allegro technique, namely Dynamic Quadrature Offset
Cancellation, removes key sources of the output drift induced by
thermal and mechanical stresses. This offset reduction technique
is based on a signal modulation-demodulation process. The
undesired offset signal is separated from the magnetic field-
induced signal in the frequency domain, through modulation.
The subsequent demodulation acts as a modulation process for
the offset, causing the magnetic field-induced signal to recover
V+
(A) Low side sensing
ECU
A
Figure 3. Chopper stabilization circuit (Dynamic Quadrature Offset Cancellation)
GND
Hall Element
A115x
VCC
R
SENSE
GND
Regulator
C
0.01 μF
BYP
A
Package UA Only
its original spectrum at base band, while the DC offset becomes
a high-frequency signal. The magnetic-sourced signal then can
pass through a low-pass filter, while the modulated DC offset is
suppressed. The chopper stabilization technique uses a 350 kHz
high frequency clock. For demodulation process, a sample and
hold technique is used, where the sampling is performed at twice
the chopper frequency. This high-frequency operation allows
a greater sampling rate, which results in higher accuracy and
faster signal-processing capability. This approach desensitizes
the chip to the effects of thermal and mechanical stresses, and
produces devices that have extremely stable quiescent Hall out-
put voltages and precise recoverability after temperature cycling.
This technique is made possible through the use of a BiCMOS
process, which allows the use of low-offset, low-noise amplifiers
in combination with high-density logic integration and sample-
and-hold circuits.
Chopper-Stabilized, Two Wire
Clock/Logic
Amp
V+
A
(B) High side sensing
GND
Hall-Effect Switches
115 Northeast Cutoff
1.508.853.5000; www.allegromicro.com
Allegro MicroSystems, Inc.
Worcester, Massachusetts 01615-0036 U.S.A.
Low-Pass
Filter
A115x
VCC
R
SENSE
GND
C
0.01 μF
BYP
8