Wi.DP1205-433-EVM-R Radiotronix, Wi.DP1205-433-EVM-R Datasheet - Page 14

• Manufacturer Part Number: Wi.DP1205-433-EVM-R
• Description: RF Modules & Development Tools Evaluation Module for Wi.DP1205-433-R
• Manufacturer: Radiotronix

Specifications of Wi.DP1205-433-EVM-R

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: WIDP1205-433-EVM-R

WI.DP1205-XXX-R DATASHEET
7. Operating Modes
By default, the serial control interface is used for configuration. It is also possible to change between the four
modes (sleep, stand-by, receive, transmit) by using the two-bit signal SW (1:0). This option is enabled by setting
the bit MCParam_Select_mode to ‘1’ in the configuration register.
If MCParam_Select_mode is low, the modes are defined by the register through the SPI_CONFIG interface and
SW(1:0) may be used as an output to control, for example, an antenna switch.
Table 6, Operating Modes
MCParam_Select_Mode
Bit 5, Address 0
0
1
Set in Output
Sleep Mode
Receive Mode
Transmitter mode -> SW(1:0) = “10”
Stand-by Mode
SW(1:0) = 00 ->Sleep Mode
SW(1:0) = 01 -> Receive Mode
SW(1:0) = 10 -> Transmitter mode
SW(1:0) = 11 -> Stand-by Mode
SWITCH (pin) SW(1:0)
-> SW(1:0) = “01”
-> SW(1:0) = “00”
-> SW(1:0) = “00”
13
10 -> Transmitter mode
00 ->Sleep Mode
01 -> Receive Mode
11 -> Stand-by Mode
MCParam_Chip_Mode Bit 7-6,
Address 0
x
Chapter
7