ST92F150-DBE STMicroelectronics, ST92F150-DBE Datasheet - Page 140

• Manufacturer Part Number: ST92F150-DBE
• Description: MCU, MPU & DSP Development Tools ST9 Dedication Board
• Manufacturer: STMicroelectronics

Specifications of ST92F150-DBE

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST92F124/F150/F250 - RESET AND CLOCK CONTROL UNIT (RCCU)
7.6 RESET/STOP MANAGER
The Reset/Stop Manager resets the MCU when
one of the three following events occurs:
– A Hardware reset, initiated by a low level on the
– A Software reset, initiated by a HALT instruction
– A Watchdog end of count condition.
The event which caused the last Reset is flagged
in the CLK_FLAG register, by setting either the
Figure 70. Oscillator Start-up Sequence and Reset Timing
140/429
9
Reset pin.
(when enabled with the SRESEN bit of the
CLKCTL register).
V
OSCIN
OSCOUT
INTCLK
RESET
PIN
V
DD
DD
MAX
MIN
T
STUP
SOFTRES or the WDGRES bit or both; a hard-
ware initiated reset will leave both these bits reset.
The hardware reset overrides all other conditions
and forces the ST9 to the reset state. During Re-
set, the internal registers are set to their reset val-
ues (when these reset values are defined, other-
wise the register content will remain unchanged),
and the I/O pins are set to Bidirectional Weak-Pull-
Up or High impedance input. See
Reset is asynchronous: as soon as the reset pin is
driven low, a Reset cycle is initiated.
Section
VR02085A
7.3.