MAX16946EVKIT# Maxim Integrated Products, MAX16946EVKIT# Datasheet - Page 3

• Manufacturer Part Number: MAX16946EVKIT#
• Description: Power Management Modules & Development Tools 18V Remote Antenna C urrent-Sense and LDO
• Manufacturer: Maxim Integrated Products
• Type: Current Monitors & Regulatorsr

Specifications of MAX16946EVKIT#

• Maximum Operating Temperature: + 105 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 4.5 V to 18 V
• Product: Power Management Development Tools
• For Use With/related Products: MAX16946
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Table 1. Jumper Descriptions (JU1–JU7)
*Default position.
JUMPER
JU1
JU2
JU3
JU4
JU5
JU6
JU7
POSITION
_______________________________________________________________________________________
SHUNT
Open*
Open
Open
Open
1-2*
1-3*
1-2*
1-2*
1-2*
2-3*
1-3
1-4
1-5
1-2
1-4
1-2
1-2
Connects the FB pin of the device to the resistor-divider of R6 and R7, which sets the output
voltage to 5V. JU3 must be installed for proper output.
Connects the FB pin of the device to the resistor-divider of R8 and R9, which sets the output
voltage to 8V. JU4 must be installed for proper output.
Connects the FB pin of the device to GND, which configures the device as a switch.
Connects the FB pin of the device to the REG pin of the device, which sets the output voltage
to 8.5V.
Connects the SHDN pin of the device to the input voltage of the device for normal operation.
Connects the on-board pulse generator to the SHDN pin of the device, which allows the OL
output to be cleared.
Connects the SHDN pin of the device to ground for shutdown mode.
Sets the output voltage to 5V. JU1 must be installed in the 1-2 position for proper output.
Disconnects the resistor-divider of R6 and R7 when JU1 is not in the 1-2 position.
Sets the output voltage to 8V. JU1 must be installed in the 1-3 position for proper output.
Disconnects the resistor-divider of R8 and R9 when JU1 is not in the 1-3 position.
Powers U3 by connecting the voltage supply that was applied at the VIN PCB pad on the
EV kit.
User can apply an external supply to the pin of JU5 that is connected to U3.
Connects 5V pullup voltage for OL and SC (LEDs D2 and D3).
LEDs D2 and D3 not used. The SC and OL PCB pads of the EV kit are used to monitor fault
signals.
Connects the output pulse of U2 to pin JU2-3. JU2 must be in the 1-3 position for proper
operation.
Connects the output pulse of Q1 to pin JU2-3. JU2 must be in the 1-3 position for proper
operation.
MAX16946 Evaluation Kit
DESCRIPTION
3