STEVAL-MKI105V1 STMicroelectronics, STEVAL-MKI105V1 Datasheet - Page 7

• Manufacturer Part Number: STEVAL-MKI105V1
• Description: Power Management Modules & Development Tools LIS3DH Adapter Board Standard DIL 24
• Manufacturer: STMicroelectronics
• Type: Other Power Managementr

Specifications of STEVAL-MKI105V1

• Product: Power Management Development Tools
• For Use With/related Products: MEMS
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

UM0979
Figure 3.
In order to use the eMotion demonstration kit, installation of a dedicated driver is required,
which is included in the installation pack, together with a GUI interface which allows simple
interaction with the sensor. The steps required for driver and software installation are
described in the following sections.
In
highlighted.
●
●
●
●
Figure 3
Jumpers JP9 and JP10
mode. When the eMotion is used together with MEMS adapters, JP9 and J1P0 must be
fitted (see STM32 datasheet for more information).
Jumper J2
instead of using the USB connector.
Jumper JP1 allows the user to measure the sensor current consumption by connecting
a multimeter in series with its terminals
Jumpers JP4, JP5, and JP6
which are available for just some of the analog MEMS adapters (see
details). JP4 is used to set the self test feature, JP5 to handle the power-down pin, and
JP6 to reset the MEMS high-pass filter. When they are fitted on pins 2-3, these
functions are handled by the firmware itself.
some main components placed on the top layer of the eMotion kit are
Board top view
(Figure
3, ref 7) can be used to directly supply the board (from 3.5 V to 6 V)
(Figure
Doc ID 17768 Rev 1
(Figure
3, ref 10, ref 11) are used to select the STM32 boot
3, ref 8) are used to manually set some features
(Figure
3, ref 9).
Demonstration kit description
Table 1
for more
7/32