UDS100-B Lantronix, UDS100-B Datasheet - Page 47

• Manufacturer Part Number: UDS100-B
• Description: Ethernet Modules & Development Tools Single Port
• Manufacturer: Lantronix
• Type: Serial to Ethernetr

Specifications of UDS100-B

• Data Rate: 300 bps to 115.2 Kbps
• Product: Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

UDS10/UDS100 User Guide
Problem/Message
When you Telnet to port 1 to assign
an IP address to the UDS, the Telnet
window does not respond for a long
time.
When you try to assign an IP with
DeviceInstaller, you get the following
message:
No device was found at this hardware
address.
No LEDs are lit.
The UDS will not power up properly,
and the LEDs are flashing.
Reason
You may have entered the hardware
address incorrectly with the ARP
command.
The IP address you are trying to
assign is not on your logical subnet.
The UDS may not be plugged into the
network properly.
The cause is most likely one of the
following:
The hardware address you specified
is incorrect.
The device is not physically
connected to the network.
The unit or its power supply is
damaged, or the unit is not plugged
into power properly.
Various
47
Troubleshooting and Contact Information
Solution
Confirm that the hardware address
that you entered with the ARP
command is correct. The hardware
address may only include numbers
0-9 and letters A-F. In Windows and
usually in Unix, the segments of the
address are separated by dashes. In
some forms of Unix, the address is
segmented with colons.
Confirm that your PC has an IP
address and that it is in the same
logical subnet that you are trying to
assign to the UDS.
Make sure that the Link LED is lit. If
the Link LED is not lit, then the UDS
is not properly plugged into the
network.
Double-check the settings that you
specified.
Note:
an IP address to a UDS
through a router.
Try plugging the UDS into another
outlet. If this does not fix the
problem, contact your dealer or
Lantronix Technical Support for a
replacement.
Consult the LEDs section above or
the Quick Start for the LED flashing
sequence patterns. Call Lantronix
Technical Support if the blinking
pattern indicates a critical error.
You cannot assign