843996-6 TE Connectivity, 843996-6 Datasheet

no-image

843996-6

Manufacturer Part Number
843996-6
Description
Contact Insertion/Extraction Tool
Manufacturer
TE Connectivity
Type
Toolr
Datasheets

Specifications of 843996-6

Rohs Compliant
NA
Product
Extraction Tool
Features
Extraction Lance Reset Tools
Lead Free Status / RoHS Status
RoHS Not Applicable
For Use With
Micro MATE-N-LOK 3 Mm Contacts
Lead Free Status / Rohs Status
RoHS Exempt Product
PROPER USE GUIDELINES
1. INTRODUCTION
This instruction sheet describes the use of
Extraction/Lance Reset Tool 843996–6. This tool is
designed to remove Micro MATE–N–LOK Receptacle
Contacts from housings and reset the overly
depressed contact locking lance of the removed
contact. (see Figure 1).
Read these instructions thoroughly before attempting
to remove any contacts or resetting the locking
lances.
2. DESCRIPTION
The tool features a handle marked with the part
number, a contact lance release tip, a locking lance
reset portion, and a tool stop. The contact lance
release tip depresses the contact locking lance to
E
NOTE
All dimensions are in millimeters (followed by
inches in brackets). Figures and illustrations are
for reference only, and are not drawn to scale.
Extraction/Lance
Reset Tool
843996-6
Extraction/Lance
Reset Tool 843996-6
Figure 1
allow extraction of the contact. The tool stop prevents
over–insertion of the tip. The lance reset portion
repositions an overly depressed locking lance to the
proper height — assuring retention of the contact in
the housing.
3. EXTRACTION PROCEDURE
Proceed as follows:
1. While holding the connector, grasp the wire at
the rear of the housing, and push forward toward
the mating end to disengage the contact locking
lance from the connector cavity shoulder.
2. Fully insert the extraction tool tip into the
window adjacent to the circuit cavity until it bottoms
inside the window.
3. Pull back lightly on the wire and, if necessary,
move tool just enough to release the lance.
4. Remove the contact from the housing; then
remove the tool.
Micro MATE-N-LOK*
Receptacle Contact
(Typ)
www.tycoelectronics.com
408-10020
1

Related parts for 843996-6

843996-6 Summary of contents

Page 1

... The contact lance release tip depresses the contact locking lance to E Extraction/Lance Reset Tool 843996-6 Micro MATE-N-LOK* Receptacle Contact (Typ) Figure 1 allow extraction of the contact. The tool stop prevents over– ...

Page 2

... Remove tool tip and contact will be ready for re–insertion into the housing. Lance Reset Angle of 17 17.78 [.700] 12.70 [.500] Lance Reset Tip 6.35 [.250 Extraction/Lance Reset Tool 843996-6 B Lance Reset Portion Extraction/Lance Locking Lance Reset Tool Figure 2 (Figure 2B) CAUTION Damaged contacts should not be used damaged contact is evident, it should be cut from the wire and replaced with a new one ...

Related keywords