PK202-25 Matrix Orbital, PK202-25 Datasheet - Page 33

• Manufacturer Part Number: PK202-25
• Description: LCD Character Display Modules Black Background Yel/Grn Text
• Manufacturer: Matrix Orbital
• Series: PK202-25r

Specifications of PK202-25

• Character Count X Line: 20 x 2
• Module Size (w X H X T): 116 mm x 37 mm x 25.73 mm
• Background Color: Black
• Backlight Type: LED Yellow / Green
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

6.1.16 Read Version Number (254 54)
only.
6.2 Flow Control
the display. Flow control is enabled or disabled by two commands. If flow control is enabled, the display
will return an "almost full" message (0xFE) to the controller when its internal buffer fills to a defined level,
and an "almost empty" message (0xFF) when the buffer contents drop to a defined level.
6.2.1 Enter Flow Control Mode (254 58 [full][empty])
This command enables flow control. When the buffer fills so that only [full] bytes are available the display
will return an "almost full" message (0xFE) to the controller. When the buffer empties so that only [empty]
bytes remain the display will return an "almost empty" message (0xFF) to the controller.
space once more drops below the [full] level.
which would overrun the buffer. While in ’flow control mode’ the unit will return 0xFE when buffer is
almost full even though it may have already thrown rejected data away. The buffer size for the display is 80
bytes.
considered very carefully. This is a critical aspect of using this command to it’s full potential. When using a
host system or PC which contains a FIFO, the user should set the value of [full] equal to or greater than the
size of the FIFO. The reason for this is that the FIFO may be full when the host system receives 0xFE. In the
case of 16550 UART the size at its maximum is 16, therefore the value [full] should be set to 16 or greater.
6.2.2 Exit Flow Control Mode (254 59)
7 1-Wire Commands
ence. This chapter deals with the capabilities of the display and a brief introduction to the 1-Wire standard.
For more detail consult
Matrix Orbital
This command will return the firmware version number of the display as a 1 byte hex value over RS-232
The display has built in flow control which may be useful when long strings of text are downloaded to
The display will return the "almost full" message for every byte sent to the display until the used buffer
Whether the user is in ’flow control mode’ or not, the module will ignore display or command bytes
When using this command in an application, selection of the value for the buffer almost full should be
This command turns off flow control. Bytes may overflow the buffer without warning.
The 1-wire bus is capable of communicating with many devices over a single wire plus a ground refer-
NOTE Flow control applies only to the RS-232 interface. It is not available for I
PK202-25
2
C.
29