WI.232EUR-R Radiotronix, WI.232EUR-R Datasheet - Page 9

• Manufacturer Part Number: WI.232EUR-R
• Description: EMBEDDED RADIO MODULE
• Manufacturer: Radiotronix

Specifications of WI.232EUR-R

• Frequency Rf: 869.885MHz
• Module Interface: Serial, UART
• Tool / Board Applications: Wireless Connectivity-ZigBee, RF, Infrared, USB
• Sensitivity: -106dBm
• Data Rate Max: 76.8Kbps
• Supply Current: 65mA
• Maximum Frequency: 869.885 MHz
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 2.7 V
• Maximum Operating Temperature: + 85 C
• Minimum Frequency: 868.225 MHz
• Minimum Operating Temperature: - 40 C
• Product: RF Modules
• Frequency Range: 868.225MHz To 869.885MHz
• Supply Voltage Range: 2.7V To 3.6V
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

If the current draw in sleep mode is too high for a particular application, the designer can switch
power to the module through a switching transistor to “turn-off” the module when it is not needed.
If this technique is used, the volatile registers will reset to the values in their non-volatile mirrors,
so any changes from the default will have to be reloaded.
The Wi.232EUR is a very flexible module because of all of the configurable parameters it
supports. However, modules that are not configured in the same way will not be able to
communicate reliably, causing poor performance or outright failure of the wireless link. All
modules in a network must have the same mode configuration to ensure interoperability.
Every Wi.232 module has read-only internal registers that contain factory programmed
information that includes calibration data and a 48-bit MAC address that can be used by the host
application for higher level, connection oriented protocols. This MAC address can be read
through the command interface.
6.2.
The primary active state is the IDLE state. When the module is not actively transmitting or
receiving data, it is in this state. While in this state, the receiver is enabled and the module is
continuously listening for incoming data. If the module detects a pre-amble and valid start-code,
it will enter the RX_HEADER state.
Figure 4: RX State Machine
If the module is in the IDLE state and a byte is received by the UART, it will enter the TX_WAIT
state.
Wi.232EUR User’s Manual
R X D A T A
U A R T T X
Operating States
C R C
D A T A L E N < M T U
R X H E A D E R
© 2003-2007 Radiotronix Inc.
I D L E M O D E
8