WI.DP1205-868-R Radiotronix, WI.DP1205-868-R Datasheet - Page 14

• Manufacturer Part Number: WI.DP1205-868-R
• Description: EMBEDDED TRANSCEIVER RAIO-ONLY MODULE
• Manufacturer: Radiotronix

Specifications of WI.DP1205-868-R

• Frequency Rf: 868MHz
• Module Interface: SPI, UART
• Modulation Type: FSK, DTS
• Tool / Board Applications: Wireless Connectivity-ZigBee, RF, Infrared, USB
• Mcu Supported Families: DP1205
• Frequency Range: 868MHz To 870MHz
• Data Rate Max: 152.3Kbps
• Supply Voltage Range: 2.4V To 3.6V
• Supply Current: 62mA
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

WI.DP1205-XXX-R DATASHEET
7. Operating Modes
By default, the serial control interface is used for configuration. It is also possible to change between the four
modes (sleep, stand-by, receive, transmit) by using the two-bit signal SW (1:0). This option is enabled by setting
the bit MCParam_Select_mode to ‘1’ in the configuration register.
If MCParam_Select_mode is low, the modes are defined by the register through the SPI_CONFIG interface and
SW(1:0) may be used as an output to control, for example, an antenna switch.
Table 6, Operating Modes
MCParam_Select_Mode
Bit 5, Address 0
0
1
Set in Output
Sleep Mode
Receive Mode
Transmitter mode -> SW(1:0) = “10”
Stand-by Mode
SW(1:0) = 00 ->Sleep Mode
SW(1:0) = 01 -> Receive Mode
SW(1:0) = 10 -> Transmitter mode
SW(1:0) = 11 -> Stand-by Mode
SWITCH (pin) SW(1:0)
-> SW(1:0) = “01”
-> SW(1:0) = “00”
-> SW(1:0) = “00”
13
10 -> Transmitter mode
00 ->Sleep Mode
01 -> Receive Mode
11 -> Stand-by Mode
MCParam_Chip_Mode Bit 7-6,
Address 0
x
Chapter
7