SK-86R03 Fujitsu, SK-86R03 Datasheet - Page 16

• Manufacturer Part Number: SK-86R03
• Description: KIT, STARTER, JADE-L, MB86R03
• Manufacturer: Fujitsu
• Type: Evaluation Boardr

Specifications of SK-86R03

• Kit Contents: SK-86R03-01 Jade-L Eval Board, JTAG Debugger Mini-Board, TFT Display, Serial Cable, Power Supply, CD
• Mcu Supported Families: MB86R03
• Silicon Manufacturer: Fujitsu
• Features: RJ45 Ethernet Interface, SD-Card Interface, Dual
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

3
4
5
6
16
Configure the terminal program settings so that the timeout values are not too strict (e.g.
30 seconds timeout)
Unplug and then reconnect the power supply to the Jade-L Evaluation Board. The LEDs
on the board will illuminate and the terminal software window (console) should be
updated by the Jade-L Evaluation Board firmware. It should show a screen similar to the
one shown below.
Important: The actual messages shown may differ to those shown here. However, it is
important that a message from U-Boot is shown! If not, please refer to the
Troubleshooting section in this manual.
Type the ‘printenv’ command to see the complete current environment (setup).
Check your TFTP server setup (IP address) and if necessary modify your ethernet
connection to the Jade-L Evaluation Board by changing the environment variables as
indicated by the Linux commands shown below:
setenv gatewayip 169.254.148.45
setenv serverip 169.254.148.45
setenv ipaddr 169.254.148.44